Maytag Refrigerator Valve

Electronic water inlet valve that controls the appliance's water flow during fill cycles, restoring proper filling and helping prevent overfills, persistent fill errors, or water leaks when the original valve fails. What it does:

• Opens and closes to route water into the appliance when signaled by the control board.
• Responds to electronic fill commands; a failed valve can cause no-fill, continuous fill, or error-code symptoms.
• Can allow water leaks if seals or valve body fail.
• Works as the unit that meters fill volume for cycles that require water.

• Disconnect power and shut off the water supply before starting any repair.
• Inspect inlet hoses and seals when installing; replace damaged hoses or gaskets to prevent leaks.
• Test the appliance through a short fill cycle after installation and check for leaks.

This secondary water valve assembly controls water flow to the appliance's secondary water circuit, restoring proper water delivery for dispensers or ice makers. Replacing a faulty valve helps stop leaks and restore reliable filling. What it does:

• Opens and closes the secondary water path to allow water to the dispenser or ice maker
• Stops water flow when the appliance signals shutoff, preventing overfilling
• Commonly used when no water reaches the dispenser or ice maker
• Can be replaced to resolve intermittent flow, continuous filling, or valve leaks

• Disconnect power and shut off the water supply before beginning work
• Turn off and relieve pressure in the water line, then disconnect supply and outlet fittings
• Inspect and replace any damaged inlet hoses or seals; tighten fittings to manufacturer torque specs
• After installation, restore water and power, check for leaks and verify proper operation

This inlet valve controls the water flow into the appliance so it fills when needed. Replacing a faulty valve restores normal fill cycles and helps prevent water delivery problems. What it does:

• Opens and closes to allow water into the appliance during fill cycles
• Stops water flow when fill is complete to prevent overfilling
• Common symptom: appliance won't fill or has low/no water flow
• Common symptom: appliance fills continuously or intermittently

• Disconnect power and shut off the water supply before starting
• Use basic hand tools; avoid overtightening inlet fittings or damage to ports
• Inspect hoses and seals; replace damaged hoses or gaskets as needed
• After installation, restore power/water and run a test cycle to check for leaks and proper operation