Maytag Washer Guard, Shield, Barrier Parts

Size: 29 1/4 inches x 31 1/4 inches. This universal washer drip tray is large enough for duet washers and sits under the washer to protect your floors from scuffs, spill, etc. Includes a PVC drain fitting.

This pump sleeve housing is the replacement outer casing that supports and seals the appliance's pump assembly, helping maintain proper water flow and prevent leaks. Fits pump assemblies that use a sleeve-style housing for the impeller and seal. What it does:

• Houses the pump impeller and seals to keep water contained during operation
• Maintains correct alignment between the pump motor and impeller/sleeve
• Prevents leaks that can cause water on the floor or damage to nearby components
• Can reduce pump noise and vibration when cracked or warped housings are replaced

• Disconnect power and turn off water supply before starting any repair
• Remove access panels and disconnect the pump assembly
• Inspect adjoining seals, gaskets, and the impeller; replace any worn components for a reliable repair

Kit includes 2 sleeves.

This motor control board shield is a protective cover that helps guard the appliance's control electronics from heat, debris and accidental contact. Replacing a damaged shield helps reduce risk of shorts and keeps the control board installed correctly. What it does:

• Covers and protects the motor control board from dirt, lint, heat and accidental contact
• Helps prevent electrical shorts or intermittent connections caused by debris or physical damage
• Restores proper mounting and alignment for the control board if the original shield is cracked, warped or missing
• Can reduce issues that present as erratic motor behavior or control-related error codes when the board is exposed

• One motor control board shield

• Always unplug the appliance before starting work and discharge any stored energy per manufacturer guidance
• Handle the control board and connectors carefully; avoid touching circuit traces or components
• Reuse the original fasteners when possible and ensure the shield is fully seated and secured to prevent contact with moving parts
• If the control board shows signs of damage (burn marks, melted components, visible faults), replace the board rather than relying on the shield alone

This shield is a protective cover that guards internal components from debris and incidental contact, helping maintain reliable operation and reduce the risk of damage. It's a simple replacement to restore a missing or damaged cover. What it does:

• Protects motors, wiring, and other internal parts from dust, lint, and stray objects
• Helps keep components aligned and reduces vibration-related noise
• Prevents accidental contact with moving or hot parts during operation
• Restores the appliance's original protective barrier and fit

• One replacement shield

• Disconnect power to the appliance before starting any repair
• Handle carefully — edges may be sharp; wear gloves if needed
• Installation typically requires basic hand tools; follow factory instructions for correct placement and fasteners
• Secure mounting before restoring power