Mtd Parts

Engine o-ring gasket creates a compression seal between engine components to prevent oil and fluid leaks. Replace when worn or cracked. Verify fit with your model.

O-ring gasket creates a seal to prevent fluid and gas leaks in tillers and lawn equipment. Replace when cracked, brittle, or leaking. Verify fit.

Throttle cable for gas line trimmers. Connects carburetor to throttle trigger. Replace if damaged, kinked, frayed, or broken during use.

Skid shoe kit for snow throwers. Mounts to the base housing to protect the auger from ground contact. Replace if worn, cracked, or missing.

This flywheel assembly mounts on the engine crankshaft of a gas-powered line trimmer and provides the rotational mass needed to keep the engine running smoothly between power strokes. It also drives the ignition system by passing magnets over the ignition coil to generate spark. Replace this flywheel if the engine has no spark, runs erratically, or if the flywheel is cracked, has damaged magnets, or a sheared keyway.

Throttle control cable for gas line trimmers. Connects trigger to carburetor for speed control. Replace if cable is frayed, stiff, or broken.

Carburetor assembly for edgers and gas trimmers. Mixes fuel and air for combustion. Replace if cracked, damaged, or leaking to restore proper operation.

Trimmer won't start or pull cord doesn't retract? This recoil starter assembly drives the engine's combustion process for hand starting your trimmer.

Ignition coil module for gas line trimmers. Mounts to engine block to generate high-voltage pulses for spark plug. Replace if cracked or damaged.

Ignition coil module assembly for gas string trimmers. Mounts to engine block and connects to spark plug. Replace if cracked, damaged, or contacts are worn.

Ignition module for gas leaf blowers and line trimmers. Mounts to the engine to control spark timing. Replace if cracked, damaged, or missing.

Fix a gas line trimmer that won't start with this starter assembly. Replaces worn recoil mechanisms causing hard pulls or no-start conditions.

This short block assembly is a genuine MTD part, sold individually. This short block assembly can be used as a replacement part for a string trimmer, a tiller, or an edger. The short block includes the crankshaft, piston, rod, camshaft, valves, and governor. A short block assembly might be necessary if there is damage to a wide range of parts in the equipment's engine. Check for frequent stalling, misfires, or an inability to power on. Remember to always wear gloves when handling, repairing, and operating outdoor equipment. This is an OEM part sourced directly from the manufacturer, and it is sold individually. This short block assembly is compatible with the following brands: MTD, Craftsman, and Cub Cadet.

Replacement screw knob for tiller machines. Installs on control panels and adjustment assemblies. Needed when original is cracked, worn, or stripped.

Replacement fuel cap for gas trimmers and handheld lawn tools. Seals the fuel tank to keep dirt and debris out. Replace if cracked, missing, or worn.

Replace cracked or worn idler wheels on your lawn mower. This kit includes wheels and mounting hardware for smooth operation and proper belt tension.