Samsung Washer 592-49147 Parts
Genuine Samsung part
By: Samsung
Part Number: DC90-10128N
Fix tE error codes with a new water temperature thermistor. This sensor monitors wash water temp. DIY-friendly repair takes under 10 minutes.
Do-It-Yourself Stories from Customers like You
Te code error Michael H. • Blue Springs , MO • August 08, 2014
I first check the schematics to find the heat sensor. On my model it's c on the control panel. I checked the continuity on the orange and white wires. It showed some continuity but not much. I then went to the heater element and found the orange and white wires going to the thermistor. Turns out the heater element and thermistor need repalced.
Read more
More
$48.95
- Compare At:
-
$57.76
- You Save:
-
$8.81
Genuine Samsung part
By: Samsung
Part Number: DC64-00802C
Replace your washer's door boot seal when you notice water leaks, mold, or visible tears. Ensures a watertight seal during wash cycles. Verify fit by model.
Do-It-Yourself Stories from Customers like You
Front door gasket clamp broke and came out Richard E. • Jonesborough , TN • November 14, 2017
I ordered new door gasket, front and rear clamp for gasket and installed them.
Read more
More
$176.95
- Compare At:
-
$210.57
- You Save:
-
$33.62
Genuine Samsung part
By: Samsung
Part Number: DC62-00182A
Fix water leaks behind the detergent drawer with this washer upper nozzle connector. Located under the top panel. Easy 5-minute DIY repair with basic tools.
Do-It-Yourself Stories from Customers like You
The problem began with the "temperature sensor problem" error Khac T. • Westford , MA • February 12, 2015
When I opened the rear cover and check the temperature sensor, I noticed the wire connection was damp. I dried it up with a hair dryer and it worked again for a few days. Then the problem came back.
When I gone back to inspect the second time, i noticed a lot of water on the floor. I knew there was a leak. I followed the disassemble samsung washer video from "Repair clinic.com" to open the top cover, then i realized the assembly hose was busted.
I ordered the parts from this site and...
Read more
More
$10.95
- Compare At:
-
$12.92
- You Save:
-
$1.97
Genuine Samsung part
By: Samsung
Part Number: DC63-00960A
The Washer Door Lock Bezel Cover-Switch Assembly is an essential component for maintaining the functionality and security of your Samsung washer. This genuine OEM part ensures a perfect fit and reliable performance, matching the original design of your appliance. The assembly combines both the bezel cover and the switch, providing a seamless replacement that restores the door locking mechanism to its optimal state. By choosing this Washer Door Lock Bezel Cover-Switch Assembly, you benefit from enhanced durability and precise operation, preventing issues such as door leaks or malfunctioning locks. Installation is straightforward, allowing you to easily replace a damaged or worn-out part without the need for professional assistance. Compatible with a wide range of Samsung washer models, this genuine OEM part guarantees compatibility and longevity. Investing in this high-quality assembly helps maintain your washerGÇÖs efficiency and extends its lifespan, ensuring that your appliance continues to deliver excellent washing performance. Trust in this reliable component to keep your washer running smoothly and securely.
Do-It-Yourself Stories from Customers like You
Washer door wouldn't close, Cierra G. • Fort Worth , TX • October 06, 2017
Ordered part by looking at parts diagram and followed You tube instructions. Easy and quick!
Read more
More
$5.46
- Compare At:
-
$6.55
- You Save:
-
$1.09
Genuine Samsung part
By: Samsung
Part Number: DC34-00024B
Washer won't start or door won't open? A faulty door lock assembly is the likely cause. This repair takes about 15 minutes with basic tools.
This part fixes the following symptoms
-
Will not agitate
-
won't spin
See more...
Do-It-Yourself Stories from Customers like You
Front door latch mechanism went bad Charlest D. • Richmond , VA • March 17, 2014
Ordered part took seal off to gain access..couple of screws and connectors..bk in business
Read more
More
$152.95
- Compare At:
-
$180.48
- You Save:
-
$27.53
Genuine Samsung part
By: Samsung
Part Number: DC97-15273A
Fix leaks or mold buildup with a new washer drain hose. Channels water away from the drum. Moderate DIY repair—requires back panel removal.
Do-It-Yourself Stories from Customers like You
It's drain hose had a lot of mold in it Larry H. • Mount Horeb , WI • December 04, 2015
Bought and installed a new drain hose. It required removing the back access panel and loosening a pinch clamp that holds the hose on its male outlet end, and threading the hose out the back of the washer.
Read more
More
$66.43
- Compare At:
-
$78.39
- You Save:
-
$11.96
Genuine Samsung part
By: Samsung
Part Number: DC62-00167A
Fix leaking during rinse or spin cycles with this washer check valve ball. Prevents water siphoning and maintains proper water levels. Easy DIY repair.
Do-It-Yourself Stories from Customers like You
Leaking during rinse/spin stage Alessandro F. • San Jose , CA • March 07, 2015
Replacing the upper nozzle connector did the trick.
I could not see damage in the older upper nozzle, it is possible that I could have fixed this just by tightening the parts - but i am happy I purchased both the upper nozzle and check valve ball, it feels good to have installed brand new parts in the washer.
Read more
More
$6.56
- Compare At:
-
$7.81
- You Save:
-
$1.25
Genuine Samsung part
By: Samsung
Part Number: DC61-02427D
The Washer Liquid Soap Dispenser Tray is an essential component for maintaining the efficiency of your Samsung washer. This genuine OEM part is specifically designed to hold and dispense liquid detergent accurately, ensuring that each laundry cycle receives the right amount of soap for optimal cleaning performance. Crafted with durability in mind, the dispenser tray withstands regular use and resists cracking or leaking, providing a long-lasting solution for your appliance. Installing the Washer Liquid Soap Dispenser Tray is straightforward, making it an ideal choice for DIY repairs. Its precise fit guarantees seamless integration with your Samsung washer, restoring the functionality of the liquid soap dispensing system without any complications. By replacing a damaged or malfunctioning tray with this genuine OEM part, you enhance the overall performance of your washer and extend its lifespan. Compatible with a variety of Samsung washer models, this liquid soap tray offers reliable and consistent detergent delivery, helping you achieve cleaner, fresher laundry with every wash. Choose the Washer Liquid Soap Dispenser Tray for a dependable and efficient solution to keep your washer operating smoothly.
Do-It-Yourself Stories from Customers like You
Detergent cup full of water at end of cycle Daniel M. • Tinley Park , IL • May 06, 2016
Replaced with new Detergent cup and fill cap. Cup symphony perfectly. Simple fix for frustrating problem.
Read more
More
$28.78
- Compare At:
-
$34.25
- You Save:
-
$5.47
Genuine Samsung part
By: Samsung
Part Number: DC96-01703B
Fix a washer stuck mid-cycle or showing overfill errors with a new water level pressure switch. This part detects water levels to control fill cycles.
This part fixes the following symptoms
-
Will not stop filling with water
See more...
Do-It-Yourself Stories from Customers like You
Samsung washer was getting stuck on 7 minutes and making lots of noise while spinning. Chris C. • Rocky Point , NY • September 01, 2017
Machine was a front load washer, after doing some research found that problem is usually caused by pressure sensor or the spider arm which attaches motor to tub.
Read more
More
$82.95
- Compare At:
-
$99.54
- You Save:
-
$16.59
Genuine Samsung part
By: Samsung
Part Number: 6002-000213
The Refrigerator Screw-Tapping is an essential component for maintaining your Samsung refrigerator's functionality. This genuine OEM part ensures precise threading, allowing screws to be securely fastened without damaging the surrounding materials. Designed specifically for Samsung refrigerators, it guarantees a perfect fit and reliable performance. Whether you are replacing a damaged screw-tapping or performing a repair, this Refrigerator Screw-Tapping simplifies the process, saving you time and effort. Its high-quality construction provides durability and long-lasting support for your appliance. By choosing the Refrigerator Screw-Tapping , you ensure your refrigerator remains sturdy and functional, enhancing its overall lifespan. This genuine OEM part is easy to install and seamlessly integrates with your existing setup, making it an ideal choice for DIY repairs. Trust in the quality and compatibility of this Samsung part to keep your refrigerator operating smoothly and efficiently.
Do-It-Yourself Stories from Customers like You
Dryer would not start. John K. • Lawrenceville , GA • November 03, 2017
The start button had been tricky to use. You had to push it in just a certain way to get the dryer to start. Eventually it was non-responsive. All other controls worked and there was no error code displayed. The repair was to replace the whole control board which cost around $100. Heavy sigh..
Be sure to keep track of all your screws.
BTW it was not the thermal fuse. All the online videos say this is the first thing to look for when the dryer will not start. Be sure to check with the person...
Read more
More
$6.41
- Compare At:
-
$7.56
- You Save:
-
$1.15
Genuine Samsung part
By: Samsung
Part Number: DC61-01257L
Supports the drum and absorbs vibrations to reduce noise and prevent walking during spin cycles. Replace if washer is unbalanced or excessively noisy.
Do-It-Yourself Stories from Customers like You
Washer would walk all over the room during spin cycle William E. • Flowery Branch , GA • December 06, 2019
Only run 2 loads through after the repair, but I fixed it by replacing all suspension components. I replaced the 2 front shocks, the 2 rear shocks (different part number), and the 2 springs. I followed the repair video and it was close enough for the whole job to be done in an hour. The hardest part was getting the door spring out from around the gasket.
Read more
More
$53.95
- Compare At:
-
$64.20
- You Save:
-
$10.25
Genuine Samsung part
By: Samsung
Part Number: 6009-001522
Replacement hex screw for dryers. Fastens internal components securely in place. Order when original screws are stripped, missing, or lost during repair.
More
$14.14
- Compare At:
-
$15.55
- You Save:
-
$1.41
Genuine Samsung part
By: Samsung
Part Number: DC62-00310A
Fix washer leaks caused by a failed nozzle connector. This water distribution part secures the connection in your washer's system. DIY repair.
Do-It-Yourself Stories from Customers like You
Plastic check ball valve was leaking. Thomas R. • Millstone , NJ • October 14, 2017
Ordered the part of the check valve body that was leaking and a new ball for the check valve, put the parts together and it fixed the problem, the only problem was plugging the small tube which my machine does not use, I simply made a small pin and glued it in the small tube with some high strength lock tite, easy fix !!
Read more
More
$10.95
- Compare At:
-
$12.92
- You Save:
-
$1.97
Genuine Samsung part
By: Samsung
Part Number: DC67-00444A
The Washer Max Fill Cap is designed to regulate the maximum water level in your Samsung washer. This genuine OEM part ensures that your appliance fills with the optimal amount of water for each wash cycle, enhancing cleaning efficiency and conserving water. By maintaining the correct fill level, the Max Fill Cap helps prevent overfilling, which can lead to leaks or excessive water usage. If your original fill cap is damaged or worn, replacing it with this genuine OEM part restores your washer's performance and reliability. Installation is straightforward, allowing you to quickly restore your washer's functionality without hassle. The Washer Max Fill Cap is compatible with a range of Samsung washer models, providing a reliable solution for maintaining your appliance's efficiency. Using this genuine OEM part ensures that your washer continues to operate smoothly, meeting Samsung's high-quality standards. Trust in the Washer Max Fill Cap to deliver lasting durability and consistent performance, keeping your laundry routine running seamlessly.
Do-It-Yourself Stories from Customers like You
Detergent cup full of water at end of cycle Daniel M. • Tinley Park , IL • May 06, 2016
Replaced with new Detergent cup and fill cap. Cup symphony perfectly. Simple fix for frustrating problem.
Read more
More
$8.76
- Compare At:
-
$10.34
- You Save:
-
$1.58
Genuine Samsung part
By: Samsung
Part Number: DC97-17022B
Replace your washer's detergent dispenser cup when tabs break or the cup is missing. Snaps into place in the detergent drawer. Verify fit with your model.
Do-It-Yourself Stories from Customers like You
Misplaced the liquid detergent cup Melissa B. • South Lake Tahoe , CA • June 23, 2019
Bought the replacement part and dropped it in the detergent drawer! - very easy!
Read more
More
$21.95
- Compare At:
-
$26.12
- You Save:
-
$4.17
Genuine Samsung part
By: Samsung
Part Number: DC97-14493B
Fix leaking from the soap dispenser area or fabric softener not emptying. This washer dispenser housing assembly repairs water leaks and flow issues.
Do-It-Yourself Stories from Customers like You
One of the nipples cracked and broke off the dispenser drawer housing (dc97-14493a) the p/n was discontinued and could only get entire kit with valves for $200 Tom P. • Beaverton , OR • January 15, 2020
I ordered a slightly different p/n (DC97-14493B) and being I'm a fairly capable DIYer, I made a minor modification to make the part I needed (DC97-14493A). The opening for the Assembly Guide Water, Silver Care Kit was blocked. I carefully drilled small holes in the four corners of the opening and using a very sharp knife, I cut out the plastic blocking the opening. Note: the schematic molded in the top of the plastic housing was incorrect for my model, so mark your water lines first or use the...
Read more
More
$73.95
- Compare At:
-
$87.26
- You Save:
-
$13.31