Power Screw, Shaft, Pin

This replacement stud is a factory-specified piece of hardware used to secure components in your appliance. Replacing a worn, stripped, or missing stud restores a solid fit to help reduce looseness and vibration. What it does:

• Provides a mounting point to fasten specified parts or panels
• Helps keep components aligned and secure during operation
• Replaces damaged, corroded, or missing original hardware
• Can resolve symptoms like loose parts, rattling, or misalignment where this fastener is used

• 1 stud

• Disconnect power; shut off water and/or gas supply if applicable
• Access the mounting location per your model's service information
• Start threads by hand to avoid cross-threading; tighten only until snug
• Reuse any original washers, clips, or nuts if required and in good condition

This slotted spring pin is a small retaining fastener that secures shafts, levers, and small assemblies so moving parts stay aligned and engaged. It restores proper mechanical retention in controls and linkages. What it does:

• Holds shafts, levers, and linkage components in place to prevent unintended movement or disengagement
• Keeps control knobs, actuator arms, and small rotating parts secured under normal operation
• Commonly replaced when the original pin is worn, bent, broken, or missing
• Helps eliminate symptoms like loose or disconnected knobs, slipping linkages, or intermittent mechanical engagement

• One spring slotted pin (single)

• Disconnect power (and water if applicable) to the appliance before servicing
• Remove the damaged pin and install the replacement using appropriate pliers or a pin punch; do not force metal parts
• Verify correct orientation and full engagement of the pin in the retaining hole before reassembling
• If the pin is difficult to seat, inspect mating parts for wear or distortion and replace any damaged components

These straight replacement pins restore secure pivot and retention points in appliance assemblies. Sold as a set of twelve, they're useful for repairing loose or missing pins that cause shifting parts or noisy operation. What it does

• Replaces worn, bent, or missing pins used to fasten pivots, linkages or small assemblies
• Restores correct alignment and movement where pins provide a pivot or stop
• Can stop rattling, binding, or uneven motion caused by damaged or absent pins
• Works wherever the OEM pin shape and size match the original anchor point

• Twelve straight replacement pins

• Compare pin shape and length to the original before installing; only identical pins should be used
• Use appropriate tools (needle-nose pliers, punch, hammer) and follow OEM disassembly instructions
• Keep springs, clips or retainers separate and reinstall in their original order
• Disconnect power and follow appliance-specific safety steps before servicing