Range / Cooktop / Oven Damper & Related

This oven vent directs hot air out of the oven cavity and helps maintain proper internal temperature and airflow. It replaces a damaged or warped vent to restore venting performance and oven appearance. What it does:

• Channels heat and steam out of the oven cavity to support even cooking
• Helps prevent heat buildup behind the oven and adjacent cabinetry
• Replaces cracked, bent or discolored vent trim that can affect airflow or appearance
• Compatible with factory vent locations — installs where the original vent was mounted

• Designed for rear/top vent mounting; verify orientation matches your appliance before installing
• Disconnect power to the appliance before beginning any service to avoid shock or injury
• Handle edges carefully; use appropriate tools to remove mounting screws and clips
• If vent damage is extensive or other components are affected, inspect surrounding parts and wiring

This ceramic catalyst oven vent fits behind the oven broiler to help vent and break down cooking residues and odors at high temperatures, keeping oven air cleaner during cooking and self-clean cycles. It's a direct-replacement part when the original is cracked, clogged, or missing. What it does:

• Provides a heat-resistant vent surface that helps oxidize grease and odors that pass through the vent during use
• Helps maintain proper oven ventilation for consistent cooking and cleaner internal airflow
• Commonly replaced when the vent is cracked, glazed-over, excessively discolored, or emits persistent odors
• Works as part of the oven's venting system—does not affect electronic controls

• Disconnect power to the appliance before starting any work to avoid shock or injury
• Allow the oven to cool fully; this part is installed inside the oven cavity or broiler area and may require removing racks or access panels
• Handle with care—ceramic components can crack if dropped or flexed; wear gloves to protect hands and avoid fingerprints on ceramic surfaces

This vent tube directs exhaust airflow from the appliance to the vent outlet, helping maintain proper ventilation and reduce leaks. Replace a damaged or crushed tube to restore safe exhaust routing and steady airflow. What it does:

• Channels exhaust air from the appliance to the vent outlet to prevent backflow into the cabinet
• Helps maintain consistent ventilation for efficient operation
• Prevents leaks and reduces the chance of moisture or lint buildup in the appliance cavity
• A worn or damaged vent tube can contribute to poor venting or unusual odors

• One replacement vent tube

• Disconnect power and unplug the appliance before beginning work
• Remove any access panels or obstructions to reach the existing tube; note routing before removal
• Secure the new tube with appropriate clamps or retainers; ensure there are no kinks or sharp bends
• If lint or debris is present, clean the vent path before installing the new tube

This plenum air piece channels and directs airflow inside the appliance to help maintain proper ventilation and heating performance. It replaces a damaged or cracked plenum to restore correct air routing and reduce airflow restriction. What it does:

• Directs and channels airflow between components to support proper heating and exhaust
• Helps prevent hotspots and uneven heating by keeping airflow pathways intact
• Restores normal venting when a cracked or broken plenum causes air leaks
• Reduces unusual air noises or vibrations caused by a damaged plenum

• One plenum-air

• Disconnect power (and gas if applicable) before beginning any service
• Remove exterior panels carefully; watch for sharp sheet-metal edges
• Verify correct orientation and fit before securing; use original fasteners where provided
• If any seals, gaskets, or mounting clips are damaged, replace them to ensure a proper seal