Range / Cooktop / Oven Damper & Related

This vent tube assembly routes exhaust and airflow inside the oven/range so the appliance can vent heat and combustion gases away from critical components. Restores proper internal venting and can reduce overheating or unusual odors. What it does:

• Channels exhaust from the oven cavity to the exhaust/vent path
• Helps protect wiring and components from excess heat
• Supports consistent oven temperature by allowing proper airflow
• Can address symptoms like hot spots, burning smells, or tripped safety limits when the original vent is damaged

• One tube vent assembly as shown

• Recommended for appliance technicians or experienced DIYers; disconnect power before starting
• Verify correct orientation and secure all fasteners and gaskets to prevent leaks
• Inspect adjacent parts and replace if damaged
• Follow OEM service manual steps for access and torque specs where applicable

This vent tube assembly routes exhaust air and helps direct airflow away from the appliance to maintain proper ventilation and operation. It replaces a damaged, cracked, or disconnected tube to restore correct air discharge. What it does:

• Channels exhaust airflow from the appliance to the external vent path
• Prevents air leaks that can reduce venting efficiency or cause mild odors
• Replaces tubes that are cracked, split, corroded, or otherwise damaged
• Helps maintain consistent airflow for proper appliance performance

• One vent tube assembly as shown

• Disconnect power (and gas if applicable) and unplug the appliance before beginning work
• Use appropriate tools and fasteners; do not overtighten clamps to avoid crushing the tube

This replacement tube vent routes exhaust from the appliance to the rear vent opening to help maintain proper airflow and reduce heat/smoke buildup in the cabinet area. It fits where the original vent tube was installed. What it does:

• Channels hot air and combustion byproducts safely away from the appliance cavity
• Helps restore proper venting when the original tube is cracked, bent, or missing
• Reduces heat transfer to nearby components and control surfaces
• Can stop symptoms like poor venting, unusual odors, or smoke accumulation near the appliance

• Turn off and disconnect power and gas before servicing; allow appliance to cool
• Use original hardware or OEM-recommended fasteners to secure the vent tube
• After installation, test appliance operation and check for proper venting and clearance

This vent assembly is the replacement exhaust vent that routes air from the appliance to the outside or to the internal ducting, restoring proper airflow and helping maintain efficient operation. What it does:

• Replaces a damaged, cracked, clogged or missing exhaust vent assembly
• Directs hot air and moisture away from the appliance to prevent performance issues
• Helps reduce unusual odors and poor venting caused by broken vent components
• Fits into the appliance's ventilation system to restore proper airflow

• One vent assembly

• Disconnect power (and gas, if applicable) before starting any repair
• Follow manufacturer diagram and instructions for proper alignment and secure mounting
• Inspect surrounding ductwork and seals; replace any damaged hardware or gaskets