Need Help?
Call or text
If your range burner won't heat or stays on high, the infinite switch likely failed. This control regulates surface element temperature levels.
Replace a faulty infinite switch when your range burner won't heat, stays on high, or cycles incorrectly. Controls surface element temperature settings.
Fix a burner that won't turn off or a fan that runs continuously. This cooktop infinite switch restores proper temperature control. Moderate difficulty.
It required that you take off the top of the stove. The micro switch is between the inside pan for the burners and the outer frame that holds the complete stove top in place. The removal of the screws and nuts that hold the switch in place was not to bad, but you had to make sure that the nuts did not drop down into the outer pan. The replacement of the nuts and screw was a pain. You are working blind trying to put the screws thru the micro switch and then having to line up the nuts to go... Read more
Microwave won't start or runs with door open? This interlock door switch is a common fix. DIY repair in under 30 minutes with a torx bit.
Knowing the odds of 2 failures occurring at the same exact time was unusually high, I just searched your site for what other broken items might affect these two failures. Came up with next control item upstream and tallied that item failure with percentages of successful repairs, (4 mins.) door safety switch. Since I had to change out the most likely of the 3 and since I was already was going to be into the switch panel I ordered all 3 and swapped them all out to cover my butt, as they were... Read more
Usually ships within 4 - 14 days
Exhaust fan won't turn off or stuck on? This rocker switch restores reliable blower control. Simple 5-minute fix—just disconnect wires and snap in new.
SSVD48600Pon finally popped the control panel loose from the top of the stove. Took some manipulation as the stove is more than 20 yrs. old With a screwdriver finally popped the switch loose. Applied the new switch. Popped the top back to the control panel. Put the screws back in and everything was back to normal. Read more
If your range burner only works on high or won't shut off, the infinite switch likely failed. Moderate DIY repair with wiring diagram included.
The new switch was a little different than the old one. Following the instructions made it easy on which wire when where. First unplugged the oven then I took out the long light bulb on the very top then took out the 2 screws under the bulb. Second take out one screw on the top left side. Next pull the control panel up and out, laying it on the stove top. I took a picture of the wiring of the back of the switch just in case I needed to refer back to it. Moved each wire to the new switch using... Read more
Fixes oven light staying on or not turning on when door opens. This oven door light switch controls interior lighting. Simple 15-minute repair.
Oven light won't turn on when door opens? This door-activated switch controls interior lighting. Simple front-access replacement restores function.
Took the side panel off and pushed it to the front and then disconnected the wires. Put the wire on the new part and pushed it back into the hole and then put the side panel back on. Then plug In the stove and it worked fine. Read more
Replace a range burner that won't heat, overheats, or has no temperature control. This 8-inch surface element infinite switch regulates cooktop heat levels.
Range burner not heating properly or won't adjust temperature? This infinite switch controls surface element heat levels. Moderate DIY repair in 30-45 minutes.
Fix a non-responsive or flickering burner control with this range burner control switch. Restores normal element operation and temperature selection.
After research and prayer I ordered the parts I believe correct. The no hassle return option helped my confidence to move forward. The parts arrived when promised and I began to remove an old part and install the new one so that I hooked the electrical properly. It must have worked since it all became operational when the stove was plugged back in. Amazing! Read more
Burner won't heat or stays on high? This infinite switch restores variable temperature control to your range surface element. Direct fit replacement.
If your range oven light won't turn on or off, this rocker-style light switch restores control. Simple plug-in replacement takes 15-20 minutes.
Burner won't heat or stays on when turned off? This infinite switch controls surface element temperature. Moderate DIY repair with basic wiring knowledge.
Fixes burner that won't heat or adjust temperature properly. This 6-inch surface element switch restores precise heat control to your electric range cooktop.
Range burner not heating or stuck on high? This infinite switch controls surface element temperature. Common fix for unresponsive cooktop controls.