Refrigerator Air Duct Or Vent

This vertical vent duct is a direct-replacement exhaust channel that routes hot, moist air from the appliance to the home vent, helping maintain proper airflow and reduce moisture or heat buildup around the unit. What it does

• Channels exhaust air from the appliance to the household vent line.
• Helps prevent exhaust air from leaking into the room and reduces backflow.
• Common symptoms it can address: long drying cycles, excess humidity or heat near the appliance, and visible exhaust escaping into the room.
• Fits into the appliance's existing vent connection to restore correct airflow.

• Turn off and disconnect power (and gas, if applicable) before servicing.
• Verify the existing vent path is clear and the duct orientation matches appliance connections.
• Use basic hand tools; avoid crushing or kinking the duct during installation.

This evaporator fan plenum is the molded housing that channels cold air from the evaporator across the refrigerator compartments, helping maintain even cooling and efficient airflow. It replaces a cracked, damaged, or warped plenum. What it does

• Directs airflow from the evaporator fan to the fresh-food and freezer sections for consistent temperature distribution
• Helps prevent air leaks around the evaporator area that can reduce cooling performance
• Often replaced when the original housing is cracked, broken mounting tabs are present, or airflow is obstructed
• Works with the evaporator fan and ducting to reduce frost buildup caused by disrupted airflow

• One evaporator fan plenum housing

• Disconnect power to the appliance before starting any repair
• Removal typically requires accessing the evaporator compartment and detaching mounting screws and any electrical connectors or duct clips
• Handle carefully; edges may be sharp and mounting tabs can be brittle on older units
• Verify alignment of the plenum with the evaporator fan and sealing surfaces to avoid air leaks after installation

This vent tube routes air or drain flow inside the refrigerator, helping maintain proper circulation and drainage in affected compartments. It replaces a worn, cracked, or clogged vent tube to restore normal airflow or drainage. What it does:

• Directs airflow or condensation safely through internal channels to prevent pooling or reduced circulation
• Helps clear minor blockages that can cause uneven cooling or water buildup
• Restores the intended airflow path after damage, cracks, or deformation
• Compatible with the refrigerator's existing mounting points and hose connections when the correct OEM part is used

• Disconnect power (and water supply if applicable) before servicing the appliance
• Remove the appropriate access panels to reach the vent tube; keep track of clips and fasteners
• Inspect surrounding seals and channels; replace or clean as needed to ensure proper function