Refrigerator Touch Pad

This nameplate recess assembly secures and seats the appliance nameplate on the control panel area for a clean, finished appearance and proper identification. It restores proper fit and prevents the nameplate from rattling or falling out. What it does:

• Provides the mounting pocket and support for the appliance nameplate on the control panel
• Keeps the nameplate flush and aligned for a factory appearance
• Stops movement or vibration that can cause rattling or partial detachment
• Helps protect the nameplate edges from catching or damage during use

• Disconnect power to the appliance before starting any work
• Remove the necessary trim or control panel screws to access the nameplate area
• Align the recess assembly tabs with the panel openings and snap or fasten into place; retain any original clips or screws
• Handle parts carefully to avoid scratching finishes or damaging the nameplate

Fix unresponsive dispenser controls with this refrigerator touchpad nameplate assembly. Restores water and ice dispenser functionality. 30-45 minute repair.

This nameplate recess assembly is the door trim piece that holds and protects the appliance's exterior nameplate, restoring a clean, finished appearance and securing the emblem area. What it does

• Replaces a cracked, broken, or warped recess that can let the nameplate sit loose or appear misaligned
• Provides a stable mounting surface so the nameplate stays flush with the door
• Restores the original cosmetic finish and helps prevent debris buildup behind the nameplate
• Fits the factory location and matches the appliance's exterior trim color

• One nameplate recess assembly (black)

• Disconnect power to the appliance before beginning any door or panel work
• Removal typically requires taking off the door or outer panel and removing fasteners; keep track of small clips and screws
• Use non-marring tools to avoid scratching the door finish; test-fit before final fastening

This recessed nameplate pocket replaces a damaged or missing nameplate mounting area on the appliance door, restoring the recessed cavity that holds the model/serial label and keeps it flush with the surface. It improves appearance and secures the nameplate. What it does

• Provides the recessed cavity that holds and protects the appliance nameplate or label.
• Restores a flush, finished mounting area after cracks, breaks, or missing trim around the nameplate.
• Helps prevent the nameplate from catching or peeling by keeping it seated in the pocket.
• Fits into the existing opening and re-establishes a neat appearance for the door or panel.

• One nameplate recess assembly (single replacement piece).

• High-level replacement: remove the door/panel trim or hardware as needed to access the damaged recess; install the new recess into the factory opening.
• Use basic hand tools; fasteners or clips may be required if present — only what is shown in the OEM diagram ships.
• Keep fingers clear of sharp edges; wear gloves if needed and avoid forceful prying that can crack surrounding trim.

A molded nameplate recess assembly that secures and frames the appliance model/serial/nameplate for a clean, protected display. Restores a flush, finished appearance where the nameplate sits. What it does:

• Holds and protects the appliance nameplate so model and serial information stays visible and secure
• Keeps the nameplate flush with the cabinet to prevent snagging or peeling
• Replaces cracked, broken, or missing nameplate pockets that expose the label
• Helps maintain a finished exterior look on the appliance

• One nameplate recess assembly

• Disconnect power and empty nearby shelves before starting to avoid injury
• Typically secures with clips or screws; align tabs and snap or fasten into place
• Inspect adjoining trim and nameplate for damage; replace nameplate separately if needed