Refrigerator Ice Maker & Related

Ice maker not working or frosting over? This protective cover shields the control module from debris and moisture. Easy 30-minute DIY installation.

Not making ice or cubes won't drop? This ice maker assembly freezes water and ejects cubes automatically. Moderate DIY repair restores steady ice production.

Ice jamming or spilling from cracked bin? This ice bin assembly stores and dispenses cubes smoothly. Easy slide-in installation restores function.

Ice spilling inside freezer or dispenser not working? This ice container deflector guides cubes into the chute. Simple snap-in installation fix.

Used to prevent over ice production in the ice dispensing bucket.

Lost or broken ice scoop? This replacement scoop fits your refrigerator's ice bin perfectly. Simple snap-in installation takes just minutes.

Ice won't dispense or bucket feels loose? This ice bucket assembly collects and stores ice, includes auger and crusher. DIY-friendly replacement part.

Ice maker won't stop making ice or overflows? This shut-off arm controls ice production by signaling when the bin is full. Simple DIY fix for most models.

This ice ejector is the plastic arm that pushes cubes out of the ice maker mold and into the ice bin, restoring proper ice ejection and dispenser function. It's a direct-replacement component for affected ice maker assemblies. What it does:

• Physically strips and pushes formed ice cubes from the mold into the bin or dispenser
• Helps restore normal ice dispensing when cubes remain stuck in the mold
• Works with the ice maker's motor/gear train to time ejection during the harvest cycle
• Commonly replaced when the ejector is broken, cracked, or worn and no longer contacts cubes

• One ice ejector (ejector arm)

• Disconnect power to the refrigerator before starting any repairs
• Remove the ice maker/cover or access panel as required to reach the ejector
• Inspect related components (drive gear, motor, and mounting pins) for wear while replacing the ejector
• After installation, run a test harvest/dispense cycle to correct operation

Fix no ice production or leaking ice maker with this mold assembly. Common when water doesn't fill properly or ice freezes together. Moderate DIY repair.

Ice sits on top and won't fall into bin? This ice maker stripper pushes cubes into the collection bin. Simple DIY repair, just remove and replace.

Ice maker not ejecting ice cubes properly? This stripper arm restores correct movement and alignment in your refrigerator's ice maker. DIY-friendly repair.

Ice maker won't stop making ice or overflows? This refrigerator ice maker shut-off arm controls ice production. Direct replacement part for most models.

Ice maker not dispensing cubes or producing hollow ice? This ice maker ejector controls the ice release cycle. Moderate DIY repair for most models.