Refrigerator Insulation, Sound Dampening Parts

This evaporator block is the refrigerator evaporator coil assembly that removes heat from the freezer/refrigerator compartment to help maintain proper cooling and reduce frost buildup. What it does:

• Circulates refrigerant through the evaporator to absorb heat from the compartment
• Promotes cold airflow across the freezer and fresh-food sections when paired with the evaporator fan
• Helps control frost and ice buildup on the evaporator surface
• Common symptoms: reduced cooling, excessive frost or ice buildup, or warm freezer temperatures

• Always disconnect power to the appliance before servicing
• Replacing the evaporator typically requires accessing sealed refrigerant areas;
• Allow components to fully defrost and drain before removal to avoid water damage
• Handle the coil gently to avoid bending fins or damaging tubing

This evaporator insulator cushions and protects the evaporator assembly to help maintain proper airflow and reduce condensation and vibration-related noise. It's a direct-replacement trim/foam piece used where the evaporator meets the cabinet. What it does:

• Cushions the evaporator to prevent rubbing and vibration noise
• Helps control airflow around the evaporator for consistent cooling
• Reduces condensation and frost migration at the evaporator edges
• Helps maintain proper spacing and fit of the evaporator assembly

• Disconnect power to the appliance before accessing the evaporator compartment
• Remove applicable panels and ice/water components as needed to reach the evaporator
• Fit the insulator around or against the evaporator per the original orientation; use only recommended fasteners or adhesive if required
• Inspect adjacent seals and components before finishing

This self-adhesive foam strip provides a thin, flexible seal used to fill gaps, reduce vibration, and block drafts or moisture around appliance components. It restores a close fit and helps reduce energy loss and noise. What it does:

• Seals small gaps between panels or trim to reduce drafts and moisture intrusion
• Dampens vibration and rattling from loose or misaligned parts
• Helps prevent dust and debris from entering sensitive areas
• Supports proper airflow by reducing unwanted leaks that can affect cooling

• Clean and dry mating surfaces before applying to ensure adhesive bonds properly
• Trim to fit with scissors or a utility knife; press firmly along the entire length to secure
• For best results, apply at room temperature and allow adhesive to set before reassembling

This lower foam pad cover cushions and seals the appliance's lower access area to reduce vibration and protect internal components. It helps maintain quiet operation and prevents dust or debris from entering sensitive gaps. What it does

• Provides a soft barrier that dampens vibration and reduces noise from moving parts.
• Helps keep dust and debris out of lower openings and cavities.
• Protects edges and components from direct contact and wear.
• Supports proper fit and alignment of the lower access panel.

• Designed for simple replacement; remove the lower access panel to reach the pad area.
• Confirm orientation and full seating of the pad before reattaching the panel to avoid gaps.
• Use basic hand tools as needed and disconnect power before servicing nearby electrical components.
• If adhesive is used, replace with manufacturer-recommended adhesive or fasteners to ensure a secure fit.