Refrigerator Relay, Overload, Capacitor

This motor overload protector helps prevent the dryer motor from overheating by cutting power when excessive current or heat is detected. It restores normal operation when the motor cools or the overload is replaced. What it does:

• Protects the dryer motor from damage by interrupting power during overheating or overcurrent conditions
• Commonly used when the dryer motor won't start, hums but doesn't run, or the motor trips repeatedly
• Works with the motor start system to reduce the risk of burned windings and costly motor failure
• Resets or is replaced to restore normal motor operation after an overload event

• Always unplug the appliance before checking or replacing this part
• Inspect wiring and motor for underlying issues that can cause repeated overloads

This motor overload protector helps stop the motor when it overheats, protecting the appliance from damage and preventing unsafe operation. It's a small, replaceable safety device commonly used on motors and compressors. What it does:

• Interrupts motor power if the motor draws excessive current or overheats
• Helps prevent motor burnout and potential electrical hazards
• Can cause a no-start or humming motor when the protector has failed
• May reset automatically or require replacement depending on design

• Disconnect power before accessing or replacing the part
• Handle terminals carefully and match wiring/terminal placement exactly
• Use only the specified replacement part; do not bypass or modify the protector

This compressor overload is a replaceable start-protection device that helps prevent compressor overheating and electrical damage. Replacing a failed overload restores reliable compressor starting and helps the refrigerator return to normal cooling. What it does:

• Protects the compressor by interrupting current if the compressor draws excessive current or overheats.
• Works with the compressor start relay to help the compressor start and run normally.
• Common symptoms of a failing overload: refrigerator not cooling, compressor won't start or hums, repeated clicking or tripping.
• Small, service-replaceable part located at the compressor terminals.

• Disconnect power to the appliance before accessing the compressor and its terminals.
• Handle wiring and terminals carefully; note lead locations or take a photo before removal to ensure correct reinstallation.
• If mounting hardware or connector types differ, do not force parts.

This start device is the relay that helps the motor begin turning, restoring normal starting performance and preventing no-start or hard-start symptoms. It's a direct-swap electromechanical relay used on compatible appliances. What it does:

• Provides the momentary boost or switching needed to start the motor
• Helps eliminate hard-starting, humming, or intermittent start failures
• Routes current to the motor start winding during startup then disengages
• Works as part of the motor start circuit to protect normal operation

• Disconnect power to the appliance before servicing to avoid electrical shock
• Handle terminals carefully; ensure tight, corrosion-free connections