Actuator Ptc Parts

Flipped the circuit breaker to turn the power to the fridge off. Had to remove the faceplate to the ice/water dispenser. Had to remove approx 16 screws and unplug the circuit board. Removed water tube (That was the hardest part) ! Had to disconnect and remove the broken part and reattach the new part. Then put everything back together again. Read more

Ordered the part and easily replaced. Read more

• Won't start

Replaced lid switch and capacitor Read more

I did some research. Found a comment on this website... shake the ptc component it was ratteling... there's a ceramic disc inside the ptc. if broken, this could be the source for the ratteling sound. Sure enough that was happening... one new ptc later an all is good. Ran fridge for 3 days now... no issues It was gamble, took it.. and came out ahead. The capicitor looked as if was OK... it was not buldging... no obvious burnt marks anywhere. Tricky part was getting the 'bale' wire reattached... Read more

Removed front of dryer panel, removed top, and removed drum. Replaced motor and wheel, because the old wheel was rusted on the motor shaft, and could not be removed, so I had to break it off. Replaced motor, and reassembled. Everything works now. I also replace the switch-Pb, because the start button was getting stuck. Read more

I bought two parts. The dispenser housing shield and the funnel ice dispenser. I watched the short video on how to put it back together and I was done in just a matter of minutes. The video was such a big help. I forgot how the spring went on and was able to watch the video and put it back together in just a matter of minutes. I know I must have saved a couple of hundred dollars on a service call. Read more

Removed water catcher, then 4 screws in water/ice vault in door, then removed screws on door side (5) top (2) and bottom (2). Removed stainless door skin. Removed 4 hex head bolts in ice/water vault (containing pads) and 4 bolts on the module immediately above the vault. Pulled the vault and module above out part way to unplug one cable. Then laid on table to unplug pads. From back, each pad has a small indent preventing the pad from being pushed up and removed. Push the small indent with a... Read more

There are plenty of DIY youtube videos to show you how to replace the parts. I went ahead and replaced more than just the broken parts. I figured if I had the machine opened up, I might as well replace parts that could go out in the future. I might have gone a bit too far with all the other parts. The only part that was really broken was the wiring harness. Two of the wires had corroded from the sockets and there was no other way than to replace the entire harness. Its a bit tricky to feed... Read more

We replaced the starter and relay. Unit is working properly. We saved over $150 by replacing the parts in question. Read more

Googled the issue and was told to replace the motor relay. I ordered new relay form App. Parts Pros and it arrived in less than 2 days. After some relatively simple dis assembly of the dryer I replaced the relay. Dryer works fine now. Read more

After trouble shooting what f21 error was. I cleaned all hoses from the tube hose to all discharge hoses. I actually replace the washer discharge hose. I still got the same error. I had a few conversations with your service techs. They gave me great advice each time I called. At the end I had to replace the washer drain pump and pressure switch. we have gone 1 week without errors code so I consider the problem solved. I really like the replacement part videos. I also like the ease of... Read more

Bought part from you and got a repairman to put it in. Darlene of your staff found part I needed. Nice lady! Repairman charged $82 to do a 10 minute job. Not your fault! Read more

• Light not working

Well started with the bulb switch when that didn't work, i continue with the next switch which was the door switch, then it worked just make sure the light bulbs are good, because i went thru 4 bulbs Read more

A friend's ice dispenser was not working so I told them I'd see what I could find on the forum. Originally I thought the micro switch had gone out. When I received the part and went to replace it I found that the little plastic tab that engages the micro switch was actually broken off on the Ice Actuator. I returned the switch and got the correct part. It arrived in a couple of days. It took about 15 minutes to replace. Everything is working great now. The repair was pretty easy to do. I found... Read more

I previously ordered the heating element, thermostat, and fuse. Also the rear drum rollers. However, after completing that repair I noticed that the terminal block and power cord had some damage from an apparent overheating while allowing the dryer to continue to run in order to dry the clothes. All is well now and the unit is working just fine. I appreciate the quick delivery of all 3 orders. Read more

Replaced motor "triple switch" Part Number: AP6021090 and the thermal fuse Read more