Electrolux Dishwasher Parts

Replaced the rack. Had to take some of the old parts that were still good and snap them into place.. pretty easy. Read more

Replaced racks, Read more

• Will not dispense detergent

My husband expected we needed a new dishwasher but I insisted on trying to fix it first. You need a Torx screwdriver so make sure you have a set. A little difficult to get cover back on and lined up by myself, but I managed and this was my first attempt at major appliance repair. I replaced the entire console and the dispenser. Still working after 3 loads so my husband may have to eventually admit that I fixed it. Read more

Ordered new replacement tines from AppliancePartsPros.com. Just unsnapped the clips, removed the old rusted parts, and replaced them with the new parts I received. Read more

The part just snaps on the basket. You have to remove the clips on the end of the runner arms to be able to remove the basket. Once it was out the old arm snap off and you snap on the new arm. Only problem was my old arm was fine and I wished the company would just sell the gasket. It seems a waste to have to purchase the whole arm. The complete job took me about 10 minutes from start to finish. I ordered the part online a Sunday afternoon and it arrived at my house on Tuesday. Read more

Replaced the rack. Had to take some of the old parts that were still good and snap them into place.. pretty easy. Read more

Purchase new rack assembly, fences and brackets from Appliance Parts Pros. This was my first purchase from Appliance Parts Pros and was an excellent experience. Went to their web site. Put in my model number. Purchased these parts in which I received in two days. Put together fences. Problem solved. Read more

This was a pretty easy fix. Removed the screws around the perimeter of the inside cover of the door and pressed the outer door cover upward to release it from slots retaining it. There are four wires to remove (2 for the detergent door release and 2 for the rinse agent release). Removed the 6 screws retaining the dispenser assembly and inserted the new one. Reassembly is simply in reverse order. Problem solved for less than the cost of a service technician's call! Read more

I had to pull and clean the pressure sensor switch four times in a year. Each time more gunk accumulated. When that happens the sensor does not close the water valve. The dishawsher keeps filling and the water comes out through the overfill port. The water then goes in the catch basin under the washer and floats the emergency switch. This cuts off the water but keeps the pump running just in case. Tripping the circuit breaker is only a temp fix. What happens is the water level may have... Read more

Removed broken arm and snaped new one in place. Read more

Ordered a new seal and the install was fairly easy. Read more

Purchased part watched the video and then did the job The parts arrived quickly and fit perfectly . Read more

I would open door after initial fill and noticed little or no water. I also could not hear water flowing from control valve. I replaced the water control valve and issue resolved Read more

Replace the pressure switch. Read more