Trimmer

Plastic flex tube for gas leaf blowers. Connects engine components for airflow. Replace if cracked, split, or worn from extended use.

Engine gasket for gas leaf blowers. Ensures proper engine seal and smooth operation. Replace if damaged or leaking to prevent performance issues.

This ignition coil module generates the high-voltage spark needed to ignite the fuel-air mixture in a gas-powered string trimmer engine. It converts low-voltage current from the flywheel magnets into the spark that fires the spark plug. Replace this module if the trimmer has no spark, won't start, runs intermittently, or stalls frequently - especially after the engine warms up.

This impeller can be used as a replacement part for the small engine of a leaf blower or a leaf vacuum. The function of an impeller, which operates by rotation, is to take in the leaves and eject them out of the chute.An impeller might have to be replaced if it suffers damage that impedes it from properly ejecting the leaves from the chute. A common symptom of an impeller that needs to be replaced is that the leaves are not ejected with enough force from the chute or that the ejection process stalls or does not occur at all. If this is the case, the impeller should be removed and replaced with this genuine OEM replacement part immediately before using the leaf blower or leaf vacuum again. Remember to always wear gloves when handling, repairing, and operating outdoor equipment. This is an OEM part sourced directly from the manufacturer, MTD, and it is sold individually. This impeller is compatible with the following brands: MTD, Troy-Bilt, and Yard Man.

If your tiller won't break up soil or tines are bent or damaged, this tine assembly bores into packed dirt to loosen soil for healthy plant growth.

Tiller won't break up soil or cuts unevenly? This tine assembly restores proper tilling action. Straightforward replacement takes about 30 minutes.

Replacement flex shaft for gas line trimmers. Connects the engine to the trimmer head. Replace if bent, broken, or worn causing vibration issues.

This is a ratchet pawl assembly used in the recoil starter mechanism of a string trimmer. It engages the starter pulley to turn the engine over when the pull cord is yanked. Replace this part if the pull cord pulls freely without engaging the engine or if the trimmer fails to start due to a slipping or broken starter pawl.

Blade guard assembly for line trimmers. Protects operator from debris and rotating components. Replace if cracked, broken, or missing for safe operation.

Fastener hardware set for line trimmers. Replace missing, stripped, or damaged screws and nuts that secure internal components. Sold as individual set.

Engine o-ring gasket creates a compression seal between engine components to prevent oil and fluid leaks. Replace when worn or cracked. Verify fit with your model.

O-ring gasket creates a seal to prevent fluid and gas leaks in tillers and lawn equipment. Replace when cracked, brittle, or leaking. Verify fit.

Throttle cable for gas line trimmers. Connects carburetor to throttle trigger. Replace if damaged, kinked, frayed, or broken during use.

This flywheel is an authentic OEM replacement part sourced directly from the manufacturer. It is part of the starter assembly on trimmers and other small engines that use a pull-start system. If the engine is misfiring, overheating, or not starting, the flywheel should be checked and replaced if necessary. Normal wear and tear can lead to the breakdown of the flywheel. The flywheel is located behind the recoil starter assembly and is attached to the engine. When the starter cord is pulled, the flywheel spins to start the engine. If the flywheel is damaged and doesn't spin fully or is seized and won't spin at all, it should be replaced. A Phillips screwdriver, spark plug wrench, Torx wrench, long-nosed pliers, and a rubber hammer are needed to complete this project. A bowl or other receptacle for storing drained fuel and work gloves are also suggested. Make sure the engine is cool, and the spark plug is removed before making this repair.This flywheel is a solid metal part that is sold individually. This flywheel is designed for tillers, cultivators, and other small engines manufactured by Craftsman and Troy-Bilt.