Whirlpool Bracket & Flange

Mounting bracket for microwave installation. Secures the microwave to the wall or cabinet. Replace if bent, cracked, or missing during reinstallation.

Mounting bracket that secures the lid switch assembly in your washer. Replace if the bracket is cracked, bent, or broken, causing the switch to shift position.

Support bracket for gas ranges. Secures and stabilizes internal components. Replace if bent, cracked, or broken to restore proper structural support.

Secures your dryer on top of a compatible washer to save floor space. Replace if bracket is cracked, broken, or missing to stabilize stacked units.

This front-and-rear mounting bracket secures the appliance's front and rear assemblies to the cabinet, restoring proper alignment and support. Replacing a worn or damaged bracket helps reduce panel movement, rattling and improper fit. What it does:

• Provides a stable mounting point for the appliance's front and rear assemblies to maintain alignment and cabinet integrity.
• Stops or reduces rattling, vibration and shifting caused by loose or broken mounting hardware.
• Prevents gaps and misalignment that can affect doors, panels or controls.
• Fits original mounting locations to restore factory support.

• Bracket (front and rear)

• Disconnect power (and water if applicable) before starting any repair.
• Use the original fasteners or manufacturer-recommended hardware; do not force or bend the bracket.
• Inspect adjacent mounting points and fasteners for wear; replace any damaged parts.

Right side handle bracket for oven doors. Secures the door handle to the frame. Replace if cracked, broken, or missing. Stainless steel construction.

Secures and supports internal compactor components to keep panels and assemblies aligned. Replaces worn, damaged, or missing brackets for firm installation.

Replacement mounting bracket for ice makers. Secures interior panels and trim for proper alignment. Needed when brackets are broken, cracked, or missing.

Motor mounting bracket for freezers. Secures the motor assembly in place. Replace if cracked, broken, or causing motor misalignment or vibration.

This flange strainer fits into the dishwasher sump to keep debris out of the pump assembly, helping prevent clogs and protecting the drain system. It restores proper filtering for dependable wash and drain performance. What it does:

• Screens food particles and grit before they reach the pump impeller
• Helps reduce clog-related wash failures and odors
• Prevents solids from damaging the sump and pump components
• Maintains normal draining and circulation when intact

• Disconnect power to the appliance before servicing
• Access the sump by removing the dishwasher tub access panel or lower dish rack as required by your model
• Inspect surrounding gaskets and seals; replace any damaged seals to prevent leaks
• Test for leaks and proper draining after reassembly