Whirlpool Dishwasher Clip Or Clamp

This clamp secures flexible hoses and small-diameter tubing to fittings, helping prevent leaks and maintain proper fluid flow in appliance systems. It's a simple replacement that restores a tight, reliable connection. What it does

• Holds a hose or tube firmly on a barb or nipple to stop leaks and loss of pressure
• Keeps water, drain, or vent hoses seated during normal appliance operation
• Replaces worn, corroded, or loose clamps that cause dripping or poor connections
• Works where a small, durable clamp is required for routing or securing tubing

• One hose clamp

• Inspect hose and fitting for damage; replace hose if cracked or hardened before installing the clamp
• Tighten clamp until snug—do not overtighten; ensure even compression around the hose
• Disconnect power and water as appropriate and take safety precautions before working on the appliance

This clamp secures a flexible appliance hose to a fitting to help prevent leaks and keep connections tight. It's a small but essential part that restores a proper seal on water or drain lines. What it does:

• Holds a hose firmly to a tailpiece, barb or connector to reduce leaks and hose slippage
• Helps stop intermittent dripping or pooling caused by loose hose connections
• Restores a proper seal after hose replacement or maintenance
• Works on common appliance water/drain lines where this clamp style is used

• One hose clamp

• Disconnect power and shut off water to the appliance before starting any work
• Allow the appliance and hoses to cool if recently used; use gloves and eye protection
• Use appropriate pliers or a screwdriver (depending on clamp style) to remove and install the clamp; avoid over-tightening
• Inspect the hose and fitting for damage; replace the hose if cracked or worn

This clip is a small retainer used to secure panels, wiring, or hoses so components stay in place and operate quietly. It prevents loose parts from shifting during normal use and helps maintain appliance fit and finish. What it does:

• Holds wiring, harnesses, or small hoses in position to prevent rubbing or disconnection
• Keeps trim or access panels seated to reduce vibration and noise
• Helps maintain correct routing to avoid wear on wires and hoses
• Commonly replaced when the original clip is broken, cracked, or missing

• One clip

• Disconnect power to the appliance before attempting any repair
• Access the area and remove any panels or covers that block the clip location
• Press the clip into its mounting slot or snap the harness into the clip until it seats securely
• Replace any damaged surrounding fasteners or retainers; do not use damaged clips

This clamp secures a flexible appliance hose or tube to prevent leaks and keep connections tight. It restores proper hose seating so water or air flows where it should, reducing drift and seepage. What it does:

• Fastens a hose or tube to a barb, fitting, or pipe to maintain a sealed connection
• Prevents hose slippage that can cause leaks or reduced performance
• Helps stabilize hoses that vibrate or move during normal appliance cycles
• Commonly used on water, drain, or vent hoses in laundry and kitchen appliances

• One clamp

• Turn off and unplug the appliance and shut off water supply before starting
• Use appropriate pliers or a screwdriver for the clamp type; avoid crushing the hose
• Inspect hose and fitting for damage and replace if needed