Whirlpool Refrigerator Parts

Ordered a new one. Read more

Ordered the piece and put it in the refrigerator. Read more

• Fridge too warm
• Freezer section too warm
• Noisy

Replaced compressor fan. the video on the website showed step by step. very easy and it fixed the problem. Read more

First off I have to say that Appliance Parts Pro's saved me from hiring a repair person, and quite possibly just getting rid of my washing machine. Their video's helped out SOOOOOOOO much and the advice one of their agents gave me over their online chat helped me trouble shoot something when I got stuck. On top of this they shipped my parts fast enough that less than 12 hrs later they arrived, which allowed me to get my machine up and running way faster than the other options I had available.... Read more

Although I only needed to replace the drawer support (end cap) on the right side the kit comes with replacements for both sides. I was surprised to see that the air flow adjustment mechanism that is located on the right side end cap was not included. I should mention that I did not disassemble the drawer mechanisms before ordering the end cap(s). The kit contained only the two molded end caps - no fasteners, mechanisms, or anything else. It turns out that this was all perfectly fine. The... Read more

I took apart the old bucket with a screwdriver and put the new one with no problems. Read more

New part works great Read more

Called in. Talk to a sale rep. Told them the model number, told me that this part would work. Shipped it to me. Snapped it in about 30 seconds. Part was perfect. Read more

I bought replacement parts Read more

I just slid it in and snapped it into place. It was very easy! I am so grateful I was able to find this part at AppliancePartsPros.com. My refrigerator is fairly old and I wasn't sure the parts would still be available. Read more

Replaced the broken parts. The water leak was caused by the drain valve not directed into drain pan Read more

• Noisy

I pulled the refrigerator out, removed the back panel, disconnected the fan motor. I did not know how hard or easy it would be to remove the fan from the motor shaft so I removed the motor with the fan attached and then removed and replaced the fan. This would not be necessary if you have a lot of strength, but if you need leverage to push the fan down on the shaft you might want to disconnect and remove the motor fan assembly too. After replacing the motor assembly and reconnecting I tested by... Read more

Ordered two boards which were indicated as the possible problem. I took detailed pictures of each board before removing to assure I was reconnecting all the connections correctly. I used a long set of needle nose pliers to remove each connector. The tricky part was trying to figure out how to remove the boards. So far when I experience a power loss the frigid has successfully restarted. Fingers crossed!! Read more

Tried to put refrigerator in defrost mode and defrost would not initiate. Checked the bi-metal and heater, both tested good. Replaced the ADC board and refrigerator went in to defrost. problem solved. Read more

With your helpful video we replaced the water filter housing. That repair fixed problem. Read more

Used screwdriver to push in plastic tabs holding old unit to the top of the refrigerator box Read more