Need Help?
Call
Freezer icing up or frost building on coils? The defrost heater melts ice from evaporator coils. Moderately difficult repair, about 1 hour install time.
Fridge keept building up ice in defrost drain drain in freezer. Once the drain pan filled with ice it drips into fridge compartment. After taking things apart three times to thaw it out, decided to replace defrost components - heater and temperature switch. In addition to new parts, also added a 12 gauge copper wire hook that hangs from defrost heater into the defrost drain. After this, the defrost cycle is running as expected, but will not know if the issue is corrected until a year or so... Read more
Houses and secures your water filter for proper filtration. Replace if cracked, leaking, or filter won't seat correctly. Confirm fit with your model.
Replaced filter housing ,flushed water lines. Read more
Seals the fresh food compartment door to maintain proper temperature and prevent air leaks. Replace if torn, cracked, or not sealing properly. Confirm fit.
Replaced the gasket . Parts were were here one day after ordered . U-tube video was a big help. Went faster and easier than expected . Read more
Replacement door shelf bin for refrigerator door storage. Installs on the door to hold condiments, beverages, and food items. Replace if cracked or broken.
Replaced the cantilever bin. Read more
Replacement dairy bin door shelf for refrigerator door. Installs on door to hold butter, cheese, and dairy items. Replace if cracked, broken, or hinges damaged.
No tools needed. Whole dairy door slipped right in. Read more
Ice not dispensing? A worn auger drive bar with stripped threads prevents ice from moving through the chute. Moderate DIY repair with video guidance.
I replaced the auger motor. You have to remove complete ice maker. Everything is just like help video to do except yoke dispenser. I watched video several times. Yoke will not just tap loose, after 30 minutes of tapping, I was using screwdriver to brace. I used a Dremel tool to cut part of shaft, came off easy then. After that, the repair went great. I have ice, I noticed motor I received was stronger. Parts came on time stated and worked great. I will order again on other repairs. Read more
Ice dispenser broken or slow? The ice container assembly holds and dispenses ice through your refrigerator door. Easy DIY fix with no tools required.
Simple fix purchased complete assembly slid old one out and new one in transferring ice was hardest part Read more
Creates an airtight seal to keep cold air in and warm air out. Replace if torn, cracked, or causing frost buildup. Confirm fit with your model number.
I took off the whole gasket, all 50 screws, and then put on the new gasket. It just took some time because of the number of screws. Read more
The Whirlpool refrigerator dual solenoid icemaker water inlet valve is an OEM replacement part responsible for controlling the water flow to the refrigerator's icemaker. It is typically located at the back of the refrigerator, near the bottom, where the water supply line connects to the refrigerator. The water valve receives signals from the refrigerator's control board to open and close, allowing water to flow into the icemaker. The Whirlpool water inlet valve can also be used on Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore/Sears brand appliances. This part fixes the following symptoms:
Hello, After watching your repair videos and reading the other comments regarding the ice maker I decided it needed to be replaced due to the old age (12 years) and mysterious flakes in the ice cubes and the solenoid valves were recommended to fix the hollow ice cube problem. After watching the repair videos on the ice maker and solenoid valves I decided I could do the replacement myself. Not needing a service technician to be called out. Also while waiting for the parts to arrive, I noticed... Read more
Protective cover for the ice maker's infrared emitter sensor in the freezer compartment. Replace if cracked, broken, or missing to shield the sensor.
Followed the video you provided. Read more
Ice maker not making ice or water dispenser not working? This water inlet valve controls flow to both systems. DIY repair takes about 10 minutes.
I had verified that the water supply was healthy, so it was either the icemaker unit or the water valve. I replaced the icemake first, based on a the pareto showing it was the culprit for most other people, but it didn't help. That replacement was straightforward; the hardest part was reaching all the way back to unclip the wiring harness since I am too lazy to totally empty the bottom freezer and remove the door. So the next step was the water valve. The hardest part of this was pulling the... Read more
Ice bucket won't stay in place or dispenser not working? This latch assembly secures the bin and aligns it with the auger. Snaps in by hand in minutes.
Noticed that the ice level LED was off then removed the ice maker and checked voltage into the ice maker module (L n' V) and didn't get power. Checked continuity on the black wire (fuse) and found it ok. Checked the parts at AppliancePartsPros.com and ordered them. Came back once got the parts. Installed the new parts then noticed that the ice maker started cycling. Read more
If your fridge isn't cooling or freezer is making loud noises, the evaporator fan motor may have failed. Moderately easy DIY repair with video guide.
After checking the suggested fixes and parts on Appliance Parts Pros, I ordered the defrost thermostat and evap motor for my refrigerator, a Kitchen Aid KSSC42QTS00. Installation was very easy, simply emptying the freezer and removing the access panel in the back bottom half. Upon getting everything open, I found out that the existing evap motor was working fine, so I didn't install that part. I did install the defrost thermometer, which was a 5-minute process. I also cleared out the vent... Read more
Freezer evaporator coil icing up and refrigerator not cooling? This defrost thermostat regulates temperature to prevent frost buildup. 2-3 hour DIY repair.
My unit has a bottom freezer that is a drawer. I had to remove the drawer, rack, glides, glide tracks, and ice maker to remove the rear panel. This was a little difficult but after researching a few videos on line I learned some tricks that made it easier. I used a hair dryer to melt the ice. This is best done with 2 people having one at the back to sponge the water into a bowl from the pan to avoid a water mess. Using a bolt meter I checked the heating element and found it had continuity. I... Read more
The Bin-Cntlvr is an OEM part for Whirlpool refrigerators. This cantilever bin provides adjustable storage on the refrigerator door, allowing you to organize and access items with ease.
Causes of a bad bin-cntlvr can include cracks or breaks from heavy items, wear and tear from frequent adjustments, or damage due to mishandling. A compromised bin-cntlvr can reduce storage efficiency and may not hold items securely.
Symptoms of a bad Bin-Cntlvr include:
This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.
Replaced. Read more
Ice maker not filling or water dispenser not working? This water inlet valve controls flow to both. Easy 30-minute DIY fix for most refrigerators.
I replaced the Inlet Valve. The part arrived ahead of schedule and was approximately $10 cheaper from AppliancePartsPros.com. This is the second time that I ordered parts from this company and have had great success with each one. Thanks Larry Read more
By continuing to use our site, you agree to our Terms of Usage and Privacy Policy. You can learn more about how we use cookies by reviewing our Privacy Policy.
We use cookies to optimize website functionality, analyze the performance, and provide personalized experience to you. Use the controls below to manage your privacy preferences.
Cross-Site Advertising
When enabled, we may use cookies and similar technologies to deliver personalized advertisements based on your browsing activity across different websites. Opting out will disable third-party advertising cookies on this site.
Analytics Sharing
When enabled, we may share anonymized browsing and usage data with third-party analytics providers to help us understand how visitors use our site. Opting out will prevent this data from being shared with third parties.