Bosch Parts

White on/off button for dishwasher control panel. Replace if button won't stay pressed in, has popped out, or is cracked, broken, or missing from panel.

Fix a dishwasher that won't start or stops mid-cycle. This door switch detects when the door is closed and signals the control board to begin operation.

Secures the washer door handle to the door assembly. Replace if worn, bent, broken, or missing to restore a firm grip and prevent handle detachment.

This replacement cooking-area knob restores user control to a range or cooktop, providing a secure grip and clear position changes for accurate heat selection. Durable plastic construction matches original fit and feel. What it does:

• Replaces a worn, cracked, or missing cooking-area control knob so temperature settings can be selected reliably
• Engages the stove's control shaft to turn burners or elements on and off
• Helps prevent accidental slips or mis-selections with a firm, indexed grip
• Common symptom fix: knob won't turn, is loose, or stops responding

• One replacement cooking-area control knob

• Turn power/gas to the appliance off and allow surfaces to cool before servicing
• Pull the old knob straight off the control shaft and push the new knob fully onto the shaft until seated
• If knob does not seat, verify shaft type and knob orientation; do not force to avoid damage

Rear pump housing that encloses and aligns the drain pump assembly. Replace if cracked, warped, or damaged to restore proper water channeling.

Left side door hinge plate for your dishwasher. Replaces cracked, broken, or worn hinge plates that cause door misalignment or instability.

Exterior front panel that restores your dishwasher's appearance. Replaces dented, scratched, or corroded panels. Covers and protects inner components.

Front drum motor mounting bushing for washers. Supports the drum shaft for smooth rotation. Replace if worn, cracked, or causing misalignment issues.

This burner base supports the cooktop's burner cap and directs flame for even heating. It replaces a damaged or warped base to restore stable burner alignment and consistent flame pattern. What it does:

• Holds the burner cap in place and centers the gas flame
• Channels gas flow for proper burner operation
• Helps prevent wobbling or uneven heating from a warped base
• Commonly replaced when the base is cracked, corroded, or bent

• One burner base (B)

• Turn off gas supply and power to the appliance before servicing
• Remove surrounding burner components and reassemble in reverse order
• Inspect nearby seals and burner ports for damage; replace if necessary

Right side door hinge for dishwashers. Installs on the right side of the door frame. Replace if bent, broken, or damaged from door falling too hard.

Pressure regulator for gas cooktops maintains consistent gas flow to burners. Replace if leaking gas odor, damaged vent, or worn seals detected.

Repair set for dishwasher rack rollers. Restores smooth rack movement when wheels are broken, cracked, or worn. Installs on upper or lower racks.

This lid is the factory replacement access cover used on select Bosch appliances to restore protection and a finished appearance. It helps keep internal components covered and prevents dirt or debris from entering the compartment. What it does:

• Covers and protects the appliance compartment where internal components or controls are located
• Restores proper fit and finish to the unit's exterior after damage or wear
• Helps prevent dust, moisture, and debris from reaching internal parts that can cause issues
• Stops rattling or vibration caused by a broken or missing cover

• High-level replacement: typically unclips or is secured with screws—refer to your model's service instructions or parts diagram for exact fastening
• Disconnect power to the appliance before attempting service to avoid shock or injury
• Handle gently to avoid scratching the finish; use appropriate tools to avoid damaging mounting tabs

A 15 amp cartridge fuse that protects appliance electrical circuits from overcurrent, helping prevent damage to controls and components. Fits into inline fuse holders or boards where that specific fuse rating is required. What it does

• Interrupts circuit power when current exceeds 15 amps to protect wiring and electronics
• Commonly linked to symptoms like no power to controls, unresponsive display, or appliances that won't start
• Designed to be replaced when visibly blown or when continuity test fails
• Works as the exact rated safety fuse specified for compatible appliances

• One 15 amp cartridge fuse

• Disconnect all power to the appliance before accessing or replacing the fuse
• Replace with the identical fuse type and 15 amp rating only; do not substitute different ratings
• Handle carefully and mount fully seated in its holder or on the PCB as designed
• If the new fuse fails again immediately, stop — repeated failures indicate underlying electrical faults

Water filter head and tubing assembly holds your refrigerator's water filter securely. Replace if cracked, damaged, or leaking. Confirm fit with model number.