Craftsman Blade

This edger blade is designed as a replacement component for several edgers. It is used to edge level ground near driveways and around sidewalks to get a crisp aesthetic. After frequent use, the edger blade can become dull and stop offering the performance it did when it was new. If the edger blade has become much smaller and performance is less than expected, it will need to be replaced.A visual inspection of the edger blade will give information about whether it has been damaged or is starting to wear out. If there are chips or dings in the metal, it should be replaced. It also needs to be replaced if it was been used a lot and is smaller than half the size it was upon buying it. To do so, turn the edger on its side and use a screwdriver to lock the spindle. Remove the spindle washer and nut before installing the new edger blade.This edger blade is created for edgers manufactured by Troy-Bilt, Craftsman, and MTD. It is a genuine OEM replacement part sourced directly from the manufacturer. It comes as a single edger blade.

This chipper blade is an authentic OEM replacement part sourced directly from the manufacturer for use in chipper shredders. The blade is the workhorse of the machine, chopping the limbs and sticks into tiny particles as they pass through the machine. As the machine is used, the blades will become dull and need sharpened. Eventually, the blades may develop cracks or become so worn that they need to be replaced for the chipper to function efficiently. Chipper blades should be periodically inspected.Wear safety gear and remove the chipper's spark plug before working on the blades. Remove the bolts holding the hopper in place and set the bolts and hopper aside. Remove the housing protecting the rotor assembly and chipper blades. Remove the bolts holding the chipper blades in place. Discard the old blades. Install the new blades and reassemble the chipper. Put the spark plug back in and test the blades.This chipper blade is made of heavy-duty metal and is sold as an individual part. It does not include connecting bolts. This blade is designed for use in chippers manufactured by MTD and Troy-Bilt.

This genuine MTD shave plate, also known as a scraper bar, can be used as a replacement part for snowblowers. A shave plate,located at the bottom of the snowblower auger, scrapes snow from surfaces and feeds it into the auger drill.Gradual damage to the shave plate is to be expected in the lifespan of a snowblower, as it bears a lot of the brunt of snowblower work. Damage to a shave plate can be detected from a simple visual inspection for cracks, dents, and erosion to the metal material. If the snowblower is not clearing away snow from surfaces as well as it usually does, it is likely that the shave plate is cracked or damaged. If this is the case, it should be removed and replaced immediately. Remember to always wear gloves when handling, repairing, and operating outdoor equipment. This shave plate is compatible with the following brands: MTD, Yard Machines, Cub Cadet, Yard Man, and Craftsman. Part sold individually.

This is a trimmer deflector that is used in line trimmers. This trimmer deflector attaches to the bottom chassis and is designed to protect the operator of the trimmer from the spinning cutting line and any debris which flies up during the trimming process.A new trimmer deflector will be needed if the original is cracked, broken, or damaged in any way. If it is missing, it is important to replace it immediately for safety reasons. If the trimmer deflector is not functioning properly, the operator will notice that they are being hit by flying debris from the trimmer. Remember to wear gloves when operating or performing care and maintenance on any outdoor power equipment machines.This trimmer deflector is a genuine Husqvarna part. It is sold individually. This particular trimmer deflector is compatible with line trimmers that are manufactured by Husqvarna and Jonsered.