Need Help?
Call
Ice won't dispense but door opens? This dispenser auger motor powers the auger that pushes ice through the chute. DIY-friendly repair with video guide.
Replaced the auger motor. Read more
Ice buildup in fresh food section or around evaporator? This air handler housing kit stops warm-air leaks that cause frost and temperature swings. 30-min repair.
I removed the fresh food ice maker found the drain tube for ice maker frozen. This was causing the back of the unit to rust out. This also caused the water to run down the back of the unit the into the duct work and into the freezer causing ice buildup. I then defrosted the freezer removed the rear duct work and the freezer drain pan cover. I found the freezer drain was not draining. I removed the exterior rear cardboard cover and located the freezer drain tube removed it and found that it was... Read more
Refrigerator not cooling or running constantly? A failed condenser fan motor prevents heat dissipation. DIY repair typically takes 30-45 minutes.
REPLACED DEFROSTER, CONDENSER FAN MOTOR AND DEFROST THERMOSTAT. Read more
Refrigerator not cooling or freezer making loud noise? A failed evaporator fan motor stops cold air circulation. This DIY repair takes about 30 minutes.
Removed back panel in freezer compartment. Held on by four hex head screws. Disconnected wire assembly from panel and then replaced evaporator fan motor on kitchen table. Evaporator fan motor is attached to back side of freezer panel by four hex head screws. Easy repair to do.It took me about 30 minutes to do the repair. Read more
Loud noise or grinding from freezer? This evaporator fan motor circulates cold air in your refrigerator. Moderately easy DIY repair with basic tools.
REPLACED THE FREEZER EVAPORATOR MOTOR. PART WAS CORRECT ONE AND FIT GREAT! Read more
This motor kit drives the microwave's glass turntable to rotate food for even heating. Replacing a worn motor restores smooth, consistent turntable motion and helps prevent cold spots during cooking or reheating.
Replaced the fan and blade. Would have been easy except the mounting threads were different than the original Kenmore freezer came with. After a 14 mile round trip for 2 5/32 screws and washers, I had my freezer back. Included an improved wiring harness than the original. Read more
Fixes ice dispenser not dispensing or auger not turning. This motor assembly drives the auger shaft that moves ice from bin to chute. Moderate difficulty.
Replaced the motor, however not the easiest to do with the older refrigerators. First I had to remove the shelf that hold the ice bin. There is a small screw midway underneath the tray. Once removed the shelf is loose but still hard to remove. There is a side panel that is slotted andonce removed the shelf can then be removed, but not knowing that it is a very odd fitting unit. Then comes the unplugging which cannot be seen so it is all by feel. Once the shelf drops down the plug is now... Read more
Removed the rear cover from inside the freezer section, found the evap fan not working. Ordered replacement motor, easy change. Read more
By continuing to use our site, you agree to our Terms of Usage and Privacy Policy. You can learn more about how we use cookies by reviewing our Privacy Policy.
We use cookies to optimize website functionality, analyze the performance, and provide personalized experience to you. Use the controls below to manage your privacy preferences.
Cross-Site Advertising
When enabled, we may use cookies and similar technologies to deliver personalized advertisements based on your browsing activity across different websites. Opting out will disable third-party advertising cookies on this site.
Analytics Sharing
When enabled, we may share anonymized browsing and usage data with third-party analytics providers to help us understand how visitors use our site. Opting out will prevent this data from being shared with third parties.