Dacor Refrigerator Parts

Given all the symptoms, we figured that the control board went out. First, unplug the refrigerator. The control board was easy to access by removing a panel on the back of the fridge. I unplugged all the connectors and used a putty knife to release the board from the plastic retaining clips. There was some browning on the underside of the board and the back of the refrigerator that suggests one of the capacitors on the board blew. Install the new board by pressing it into the retaining clips... Read more

Replaced water valve and ice maker Read more

I first thought it was the auger in the ice container so I changed it and it was not the problem. I then talked to ApplianceParts customer service that it might be the yoke on the motor that turned the auger or even the motor itself even though it worked. I ordered the parts, the yoke was supposed to be able to be changed by itself but mind would not come off the motor shaft so I had to cut it off just to remove it from the unit so I had to change the motor anyway because of this. So I advise... Read more

We turned off the circuit breaker. We then removed the light cover and then the control panel. We disconnected the Keyboard, Utah, plugged in the new one and turned the breaker on to see if everything worked. We realized that we did not need a new jazz board so that is being returned. The old Keyboard was removed, the new one attached and all the parts were put back. The frig works fine now at the recommended settings of zero and 38F. Read more

If the freezer is cold and the fridge is hot, logic would indicate that the fan blowing the cold air from the freezer into the refrigerator is not working. Searched the ApplicancePartsPros.com website for a fan in the freezer compartment and found the video on how to replace one. Followed the steps in the video to get the freezer partially disassembled and found the whole back of the freezer frozen over. Plugged the refrigerator back in and verified that the fan was not working. Unplugged... Read more

We were experiencing slow water flow from our Whirlpool interior water dispenser. The water would flow normally for a couple of seconds then subside to a trickle. After replacing the water filter and inlet valve, research suggested that the water filter head could be the culprit. In about 30 minutes, I was able to remove the old part and replace with a new part solving the problem. Read more

• Freezer section too warm

The fan has a very thin wire in it's coil, and when that wire breaks, you need a new fan. In a previous repair, i noticed that an ice build-up had dislodged the wiring on my fan and severed the coil winding. I was able to undo the winding a couple of turns and get it working again. But more recently, the fan stopped and there was no repairing it. So i ordered a new fan from AppliancePartsPros.com and it got here in very good time. The new fan was slightly different as the prongs seemed to be... Read more

1. Ordered new gasket. 2. Heated with blow dryer gasket until it resumed its normal shape. 3. Turned off refrig. 4. Cleaned freezer compartment. 5. Removed old gasket. 6. Installed new gasket. 7. Turned on refrig. 8, Operation back to normal in about 6 hours. Read more

• Fridge too warm
• Noisy

I determined that the motor that drives the damper valve that allows cold air into the refer was noisy. I ordered the replacement part from AppliancePartsPro.com. It arrived within 3 days and I changed the units out, which took about 10 minutes total. All is quiet with the refer now. Read more

• Freezer not defrosting
• Fridge too warm

Toughest part of this repair is figuring out how to get things apart. Amana doesn't provide you a repair manual showing how to disengage the various plastic covers. Initially disassembled the bottom freezer compartment so I could get to the evaporator coils; they were completely frozen in block of ice, restricting air flow to the fridge above. Obviously, the auto defrost cycle had not been running, or was short-cycling. Manually defrosted. Found this link for running diagnostic tests on the... Read more

I ordered a new solenoid valve set and watched the online video of the replacement process. So after emptying my freezer and fridge, removing the doors and freezer drawer, so I could mover the fridge out of its cove, I discovered after taking the panels off the rear, that my fridge is different than that shown in the video. I went back online and discovered in one of the exploded views of the cabinet there is a panel inside the refrigerator which can be removed after taking the shelves out of... Read more

Pulled out storage bin Removed side track rail covers Popped off gear from holding clip Installed drive shaft Installed rail cover and storage bin Only took about 15 minutes Read more

• Door won't open or close

Looked for parts online that were worn and compared prices. Best price was appliance part pros. Ordered and received in 2 days and easily replaced worn parts. Read more

I replaced the drive shaft, coupling and seal and now it works well. The videos were a big help. Read more

Replaced relay and capacitor attached to compressor Read more

I bought the listed condenser fan motor for my Maytag refrigerator. Access to the condenser fan is by removing sheet metal screws of bottom panel with 1/4 in. nut driver. Condenser fan is on left side of rear access area. Remove electrical connector by pressing-in connector release tab with thumb fingernail and pulling on connector. Remove three mounting screws with 5/16 nut driver. Work fan out to the right past the compressor. I used a pair of pliers, as a lever, behind the plastic fan blades... Read more