Deflector & Chute

Channels grass clippings away from the operator on walk-behind mowers. Replace if cracked, broken, or missing to restore proper clipping discharge.

Mulch plug assembly for gas walk-behind mowers. Blocks the discharge chute to enable mulching mode. Replace if cracked, broken, or missing.

Plastic discharge chute assembly for chipper shredders. Directs wood chippings safely away from the unit. Replace if cracked, broken, or missing.

Replace your trimmer's deflector flap if cracked, broken, or missing. Shields internal components from flying debris during operation. Direct fit.

Replacement baffle for lawn mower decks. Directs airflow and grass clippings toward the discharge chute or bag. Replace if cracked, broken, or missing.

Lower chute ring for snowblowers. Secures the discharge chute assembly to the auger housing. Replace if cracked, broken, or missing for proper fit.

Mulch plug assembly for walk-behind mowers. Blocks the discharge chute opening to enable mulching mode. Replace if cracked, broken, or missing.

Plastic Shield Kit Assembly / Blade Guard

Replacement rear skirt deflector for walk-behind lawn mower decks. Prevents grass clippings and debris from flying out the back. Order a new one if yours is cracked, broken, detached, or damaged.

Front deflector baffle for 21-inch walk-behind mowers. Replaces cracked, broken, or missing dome-style baffles. Installs at front discharge area.

This genuine Husqvarna rear skirt provides protection from grass clippings and debris that could fly from underneath the lawn mower during use. Periodic inspection of the rear mower skirt for cracks and damage is an important safety measure for lawn mowers. Do not attempt to remove or install the rear skirt when the lawn mower is running. For models with clip-fasteners: Use a flathead screwdriver to remove the old skirt from the lawn mower. Line the new skirt up and reinstall the clips. For models with screw fasteners: Remove the screws holding the skirt in place, set screws aside for reuse. After removing the old rear skirt, clean the area to remove any dirt or debris. Flush installation is important in preventing debris flyout. Line the holes on the new skirt with the holes on the lawn mower. Reinstall screws and tighten. Dispose of the old skirt. The OEM skirt is made of high-quality, molded, composite black plastic. The unit is sold individually. This rear skirt does not include fastening clips or screws. Reuse fasteners on the current mower. This rear skirt compatible for use with Craftsman and Husqvarna push lawn mowers.

Rear discharge skirt for gas walk-behind mowers. Directs clippings safely away from the mower deck. Replace if cracked, broken, or missing.