Dryer Touch Pad

This 18" trim plate restores the finished look along the appliance front, covering gaps and worn edges for a clean, built-in appearance. It replaces damaged or missing trim to refresh the unit's visible surface. What it does:

• Covers the gap between the appliance and surrounding cabinetry for a seamless look
• Protects the appliance edge from chips, scratches and everyday wear
• Restores appearance when original trim is dented, bent or discolored
• Helps maintain a consistent trim line around the control/door area

• Disconnect power to the appliance before starting any work.
• Handle trim carefully—edges may be sharp; wear gloves as needed.
• Remove any fasteners or adjacent panels to access mounting points; reuse existing screws unless replacements are specified.
• Align trim to the mounting locations and fasten without over-tightening to avoid warping.

Control panel touch pad for your dryer. Installs on the front console to provide user interface. Replace if cracked, faded, or buttons are unresponsive.

This trim plate is the finished control-panel trim that restores the appliance's appearance and helps protect the underlying control assembly from spills and debris. It replaces a damaged, bent, or missing trim for a clean, finished look. What it does:

• Covers and protects the control panel area from spills, splashes, and surface wear
• Restores the appliance's factory appearance when the original trim is dented, scratched, or missing
• Helps keep dust and debris away from switches and electronic components behind the panel
• Provides a secure mounting surface for control knobs or overlays where applicable

• One trim plate as shown

• Disconnect power to the appliance before beginning any work
• Remove any control knobs or bezels and the fasteners holding the existing trim, then slide or lift the old trim off carefully
• Handle edges carefully to avoid cuts; use proper tools and avoid forcing fitment
• If electrical components are exposed after removal, do not operate the appliance until the new trim is fully installed

This console trim plate restores the front appearance of your appliance control console and covers the control-panel edge for a clean, finished look. It's a direct-fit exterior piece that repairs cosmetic damage and protects internal components. What it does:

• Covers the front edge of the control console to hide wiring and mounting hardware
• Restores a uniform, matching bisque finish after chips, dents, or paint wear
• Protects the control-panel edges from everyday bumps and spills
• Helps keep the control area sealed from dust and debris

• Disconnect power to the appliance before starting any work
• Typically installed by removing a few screws and snapping or sliding into place; keep fasteners for reassembly
• Handle carefully to avoid scratching the finish during installation
• If trim does not align, double-check that underlying brackets or supports are undamaged