Dryer Touch Pad

This console trim plate restores the front appearance of your appliance control console and covers the control-panel edge for a clean, finished look. It's a direct-fit exterior piece that repairs cosmetic damage and protects internal components. What it does:

• Covers the front edge of the control console to hide wiring and mounting hardware
• Restores a uniform, matching bisque finish after chips, dents, or paint wear
• Protects the control-panel edges from everyday bumps and spills
• Helps keep the control area sealed from dust and debris

• Disconnect power to the appliance before starting any work
• Typically installed by removing a few screws and snapping or sliding into place; keep fasteners for reassembly
• Handle carefully to avoid scratching the finish during installation
• If trim does not align, double-check that underlying brackets or supports are undamaged

This control panel is the user-facing electronic console that lets you select oven/cooktop functions and settings. It replaces a damaged or unresponsive panel to restore normal control and clear readout operation. What it does

• Houses the touchpads/buttons and display used to set temperature, timers and cooking modes
• Sends user commands to the oven control board so cycles start and stop as expected
• Can resolve symptoms such as unresponsive buttons, blank or flickering display, or incorrect mode selection
• Interfaces with the range's control electronics to provide visible status and feedback

• One control panel

• Disconnect power at the breaker or unplug the appliance before starting
• Handle the display and ribbon/connector areas carefully to avoid damage
• Basic hand tools are typically required; follow the service manual for panel removal and reassembly