Freezer Bumper, Bushing, Grommet Parts

A small rubber grommet that cushions and seals wiring or components where they pass through a panel or opening, helping protect against chafing and reducing vibration for quieter, safer operation. What it does:

• Cushions wiring or tubing where it passes through metal or plastic openings
• Prevents chafing and wear on insulation or hoses
• Helps reduce vibration and rattling at the entry point
• Maintains a more secure, stable routing for components

• Disconnect power to the appliance before servicing to reduce risk of shock.
• Remove the panel or trim exposing the opening, then press the grommet into the hole until fully seated.
• Inspect surrounding wiring, hoses, and mounting surfaces for damage and replace if needed.

A single PCB stand-off used to support and insulate a control circuit board from the appliance chassis, helping prevent shorts and vibration damage. Fits as a direct replacement where the board needs secure, spaced mounting. What it does:

• Keeps the printed circuit board elevated and electrically isolated from the metal chassis
• Reduces risk of short circuits from contact or conductive debris
• Helps limit board movement and vibration-related connection issues
• Used whenever a loose, damaged, or missing spacer causes board contact or instability

• Power off and disconnect the appliance before accessing the control board
• Replace only the same standoff location/size to maintain proper clearance
• Use appropriate non-conductive fasteners; do not overtighten to avoid cracking the spacer

This rubber grommet seals and cushions the refrigerator's water fill tube where it passes through the liner, helping prevent leaks and vibration. It's a simple, low-cost part that restores a watertight, stable tube connection. What it does:

• Provides a sealed passage for the water fill tube to prevent drips and pooling
• Cushions the tube to reduce vibration and wear
• Helps keep the fill tube properly positioned for reliable water flow
• Commonly replaced when the tube leaks, moves, or the grommet is cracked or missing

• One rubber water fill grommet

• Turn off the water supply and unplug the appliance before servicing
• Access may require removing interior shelves or liners—handle panels carefully
• Press the grommet into the liner opening and feed the fill tube through until seated

This small hinge spacer positions and supports the refrigerator door hinge assembly to ensure proper door alignment and smooth opening. It helps restore correct door spacing and prevents rubbing or uneven sealing when the hinge is worn or misaligned. What it does:

• Provides precise spacing between hinge components so the door sits and closes correctly
• Stabilizes the hinge wing to reduce door wobble and uneven movement
• Helps correct minor misalignment that can cause door binding or uneven gaps
• Works with the hinge assembly hardware to maintain consistent door sealing

• One hinge wing spacer as shown

• Intended for use with the door hinge assembly; verify hinge location before ordering
• Basic hand tools typically required; refer to your model's service manual for disassembly steps
• Disconnect power and empty the door as needed to avoid injury during service
• If hinge damage or heavy wear is present, replace the entire hinge assembly rather than only the spacer