Freezer Parts

Color: Black. Size: 12 oz. Acrylic appliance aerosol can spray paint.

The EVAPORATOR INSULATOR is an OEM part for Frigidaire refrigerators. It is a heat-resistant insulating pad or wrap that surrounds the evaporator coils. The insulator works to retain cool air and prevent warmer air from entering the refrigerated compartment.  

Causes of a bad insulator can include deterioration or breakdown of insulating properties over time due to aging materials. Cracks, holes, or compressed sections of the insulator result in reduced insulation performance.

Symptoms of a bad evaporator insulator include:

• Inconsistently cool or warmer fridge temperatures 
• Frost or ice buildup on evaporator coils or surrounding areas
• Higher than normal electric bills from inefficient cooling
• Warm or cold spots inside refrigerator shelves and compartments

This OEM Frigidaire replacement insulator is compatible with some Kitchenaid, Electrolux, Gibson, Kelvinator, and Kenmore side-by-side refrigerator models. 

Replacement screw for securing panels, brackets, and internal components in freezers and refrigerators. Use to replace missing or stripped hardware.

Kit of 24 clips

Replace your freezer door gasket to restore a tight seal, prevent warm air infiltration, and reduce frost buildup. Verify fit with your model number.

Mounting bracket that secures freezer shelves and internal panels. Replace if cracked, bent, or broken to restore proper alignment and stability.

Restore accurate cooling and responsive controls with this Electronic Control Board. It monitors sensors and user settings to manage your freezer's key operations so the unit reaches and maintains the temperature you choose.

• Regulates cooling by commanding the compressor and evaporator fan to maintain set temperature
• Interprets thermistor and keypad inputs to execute temperature changes
• Coordinates defrost timing and temperature alarm functions on applicable models
• Symptoms it may address: not cooling or overcooling, runs constantly or won't run, erratic/inaccurate temperature display, beeping alarm, unresponsive buttons or display

• Disconnect power before servicing; handle the board by its edges and use ESD protection
• Note/photograph wiring before removal; transfer any reusable mounting brackets or covers
• Ensure all connectors are fully seated and locked
• After installation, set your desired temperature and allow up to 24 hours for temperatures to stabilize

Electronic touch pad control board that mounts on the freezer door. Replace if cracked, unresponsive, or damaged by power surge. Plug-in installation.

Almond. Size: 13 oz. can. Acrylic appliance paint.

Replace your burned-out refrigerator light bulb to restore clear visibility inside your appliance. Easy installation when bulb flickers or fails.

Quantity of 1 clip.

Note: See kit# 5303922007 and 5304406520.

Fix a refrigerator that won't cool or runs constantly with this compressor. Essential sealed system component. Professional installation recommended.

Secures panels, brackets, and internal components. 10-16 thread fastener for sheet metal and plastic mounting. Replace missing or stripped screws.

This is a start relay device that helps the compressor motor start up and run properly in your refrigerator or freezer. It provides the initial electrical boost the compressor needs to begin its cooling cycle. Replace this part if your unit is not cooling, the compressor clicks on and off repeatedly, or you hear a buzzing sound coming from the back of the appliance.

White porcelain touch-up paint for repairing chipped, scratched, or worn surfaces on ranges, ovens, and refrigerators. Restores appearance on exterior panels and trim. 2 oz. can.

Replaces a cracked, brittle, or damaged fluid transfer tube in your upright freezer. Restores secure connections and prevents leaks in the system.