Frigidaire Adaptor Or Connector

This water connector links sections of the refrigerator's water supply tubing, maintaining a sealed path to the dispenser and ice maker. Replace a cracked or leaking connector to stop drips and restore reliable water flow and ice production.

• Connects sections of internal water tubing between components (inlet valve, filter, door, ice maker)
• Helps maintain a sealed route for proper dispenser and ice maker operation
• Common symptoms: water leaking behind/under the refrigerator, weak/no dispenser flow, ice maker not filling, visible damage at the fitting
• Direct-fit component built to OEM specifications for the intended application

• Unplug the refrigerator and shut off the household water supply before servicing
• Dispense water to relieve line pressure; place a towel to catch residual water
• Cut tubing ends square and fully insert into the connector until seated; tug gently to confirm engagement
• Restore water, check carefully for leaks, and recheck after the first dispense cycle

This is a push on John Guess design elbow used to connect two 5/16" plastic lines together.

This tube adapter connects and seals a refrigerator water line to the inlet or valve, restoring a secure water pathway for the ice maker or dispenser. Use it to stop leaks and re-establish reliable water flow. What it does

• Adapts and secures the appliance water tube to the inlet or valve, forming a leak-proof connection
• Restores proper water feed to the ice maker and/or water dispenser when the original adapter is damaged
• Helps prevent drips or steady leaks at the tube connection
• Works with standard refrigerator water tubing and compression fittings where specified

• One tube adapter

• Turn off the refrigerator power and shut off the household water supply before starting
• Remove the damaged adapter and clean tube ends; replace with this adapter using appropriate compression or push-fit method
• Tighten fittings to a snug, leak-free fit; avoid over-tightening plastic parts
• After installation, restore water and power, and check thoroughly for leaks

This connector door harness links the cabinet wiring to the refrigerator door, restoring electrical connections for door-mounted components. Use this harness to replace a damaged or corroded door connector and regain reliable electrical contact. What it does:

• Provides the sealed electrical connection between the cabinet wiring and the door harness
• Restores power and signal to door-mounted parts such as switches, lights, and dispenser controls when the original connector fails
• Prevents intermittent or lost connections caused by worn, damaged, or corroded terminals
• Maintains proper connector alignment and strain relief for the door wiring

• One connector door harness

• Always disconnect power to the appliance before beginning any repair
• Installation typically requires removing the door panel or inner liner to access the connector
• Inspect mating terminals and wiring for damage; replace or repair any frayed wires before reconnecting
• Ensure connectors are fully seated and secured; test door functions after reassembly

Note: This is a 1/4" x 1/4" compression elbow fitting without the nuts. See part# 4932JA3009A which is a 1/4" by 1/4" John Guess quick connector elbow.