Frigidaire Chassis Or Cabinet

Structural pan beneath the cooktop that supports burner components. Replace if corroded, rusted, has holes from spills, or damaged from heat exposure.

This is the top work surface panel that covers the upper portion of the dryer cabinet. It provides structural support and a finished exterior surface while protecting internal components from dust and debris. Replace this panel if it is dented, cracked, rusted, or if the finish is damaged.

Replace your damaged or worn range side panel. This exterior cabinet panel installs on the side of your range to restore its appearance and structure.

Replace your oven's front panel frame if cracked, dented, or damaged. This structural component installs at the exterior of your range to restore appearance.

Replace your range's control panel if the original is cracked, damaged, or showing wear. This panel mounts to the front and houses control components.

Metal trim panel that mounts above the dishwasher door under the control console. Replace when original is dented, scratched, rusted, or damaged.

This outer front panel replaces a damaged or dented cabinet front to restore the appliance's appearance and provide support for the door and front-mounted components. Durable sheet-metal construction keeps internal parts protected. What it does

• Restores the appliance's exterior appearance after dents, cracks, or corrosion.
• Provides structural support and mounting surface for the door, latch, and lower trim.
• Protects internal components from dust, debris, and accidental contact.
• Helps ensure proper door alignment and sealing when installed correctly.

• One outer front panel (quantity: 1)

• Disconnect power (and gas/water if applicable) before beginning any repair.
• Installation typically requires removing the door, trim, and/or control console to access mounting fasteners.
• Handle the panel carefully to avoid sharp edges and to prevent further cosmetic damage.
• Verify all mounting tabs and screws are secure and that the door aligns and closes properly after installation.

This is the lower access panel, also called a toe panel, that attaches to the front bottom of the washer. It covers the internal components beneath the drum area and provides a finished appearance. Replace this panel if it is dented, cracked, rusted, or if the mounting tabs are broken, leaving the lower portion of the machine exposed.

This is the mounting base that supports and secures the bake element at the bottom of the oven cavity. It provides a stable platform for the heating element and helps direct heat properly during baking. Replace this part if it is cracked, warped, or corroded, which can cause the bake element to sit unevenly or make poor electrical contact.

This is the rear panel that mounts on the back of a freestanding range, enclosing and protecting the internal wiring, insulation, and components behind the oven cavity. It helps maintain proper airflow and shields electrical connections from damage. Replace this panel if it is dented, rusted through, or missing, which can compromise insulation efficiency and expose internal components.

Structural frame component for electric and gas ranges. Replaces damaged, bent, or corroded frame that affects cabinet integrity or appliance stability.