Frigidaire Dishwasher Dispenser Parts

Dispenser door won't close or latch? Replace the detergent dispenser assembly. DIY repair takes 5-10 minutes with video guide. Fixes stuck or broken latch.

Replacement cap for dishwasher detergent dispenser. Covers and seals the dispenser compartment. Replace if cracked, broken, melted, or missing.

Soap dispenser door won't open or latch is broken? This detergent dispenser assembly fixes dispensing failures. DIY repair takes 10-15 minutes.

Fix a soap door that won't open or stay closed. This detergent dispenser releases soap at the right time during wash cycles. DIY-friendly repair.

Covers and protects the dishwasher pump assembly. Replace if cracked, broken, or if plastic guides are stripped causing spray arm support issues.

This dispenser actuator lever operates the refrigerator door dispenser so you can dispense water or ice with a simple push. It restores proper button/lever response for convenient, reliable dispensing. What it does:

• Replaces a worn or broken dispenser actuator to restore dispenser button/lever function
• Helps stop intermittent or failed dispensing caused by a damaged actuator
• Supports correct engagement of the dispenser switch for consistent operation
• Useful when the lever is cracked, loose, or does not return to position

• One dispenser actuator lever

• Disconnect power to the appliance before beginning any work
• Access may require removing the dispenser trim or inner door panel; handle panels carefully to avoid damage
• Verify correct orientation and secure mounting of the actuator during reassembly

Fix a dishwasher that won't release detergent or leaves soap residue with a new detergent dispenser. Moderately easy install in the door panel.

Replace a cracked, broken, or missing dishwasher cover. This protective cap installs on your dishwasher to cover internal components and fittings.

Fix a broken soap dispenser with this dishwasher dispenser door housing. Restores proper detergent dispensing when the housing is cracked or damaged.

Replace your dishwasher's filter assembly cover if it's cracked, broken, or missing. Installs over the filter assembly and secures under the spray arm.

This cover, volute replaces the outer half of the dryer blower housing to protect the blower assembly and help direct airflow for efficient tumbling. Restores proper airflow path and helps reduce rubbing or contact with the blower wheel. What it does:

• Replaces the dryer blower housing cover that surrounds and shields the blower wheel
• Directs exhaust airflow from the blower to the exhaust duct for correct drying performance
• Helps prevent the blower wheel from rubbing on cabinet parts or allowing foreign objects to reach the blower
• Commonly used when the original cover is cracked, warped, or missing fastener locations

• One cover, volute

• Refer to your model's service manual or diagram for exact placement and screw locations
• Disconnect power and gas before starting any repair to avoid shock or injury
• Handle sharp sheet-metal edges carefully and use appropriate hand tools; reinstall all fasteners securely
• If rust, corrosion, or additional damaged parts are present, inspect the blower wheel and housing for proper fit

This sump housing collects and channels defrost and condensation water to the refrigerator drain system, helping prevent interior pooling and ice buildup. Replaces a cracked or clogged drain housing to restore proper water flow. What it does:

• Guides meltwater from the evaporator area into the drain tube and pan
• Helps prevent water pooling or leaks inside the fresh food or freezer sections
• Reduces ice buildup around the evaporator or under the freezer floor when functioning properly
• Works with the refrigerator's drain tube and pan as part of the defrost drainage path

• One sump housing

• Disconnect power to the appliance before starting work
• Remove food and shelves as needed; allow ice to fully melt before removing the old housing
• Inspect and clean the drain tube and surrounding seals when replacing the housing