General Electric Cooktop Screws, Nuts, Washers

This replacement mounting screw secures panels and trim pieces on compatible appliances to restore proper fit and reduce rattling. Use it to replace missing or damaged screws that keep covers and components fastened. What it does:

• Fastens panels, trim, and small components to the appliance frame
• Restores secure attachment to stop vibration, noise, or loose panels
• Replaces missing, stripped, or corroded screws that prevent proper closure
• Works wherever the original screw type was used for mounting or securing parts

• Disconnect power to the appliance before servicing to avoid shock
• Use the correct screwdriver or bit to avoid stripping the head
• Start threading by hand to ensure proper engagement before tightening
• Do not over-tighten; snug until secure to avoid damaging threads or panels

This is a replacement 8-32 machine screw used to fasten panels, brackets and components on household appliances. It restores secure attachment and helps stop rattling or loose parts caused by missing or damaged fasteners. What it does

• Secures trim, control panels, brackets and electrical component mounts
• Stops rattling or vibration caused by loose or missing screws
• Replaces stripped, missing or corroded screws to restore proper fit
• Works wherever an 8-32 threaded machine screw is required

• Turn off and unplug the appliance before servicing to avoid electrical shock
• Use the correct driver and size to avoid stripping the head or threads
• Hand-start the screw and tighten progressively; avoid overtightening to prevent damage
• If threads are damaged, replace the mating nut or threaded insert as well

This 10-32 threaded machine screw secures panels, controls, and brackets on compatible appliances to restore stable mounting and stop loose or rattling parts. Use it wherever the original 10-32 fastener has worn, stripped, or gone missing. What it does:

• Fastens control panels, trim pieces, mounting brackets, and grounding or terminal connections using a 10-32 thread.
• Replaces worn or damaged screws that cause loose panels, vibrating noise, or poor alignment.
• Restores secure electrical and mechanical connections when the original fastener is stripped or corroded.
• Works with standard 10-32 tapped holes and mating nuts designed for this thread size.

• One 10-32 machine screw

• Disconnect power and follow appliance safety procedures before starting any repair.
• Use the correct screwdriver or nut driver sized for the screw head to avoid cam-out or damage.
• Tighten until snug—do not overtighten to prevent stripping the threads or damaging components.
• If threads in the mating part are damaged, replace or re-tap the mating component rather than relying on over-tightening.