General Electric Dishwasher Parts

Replacement 8-32 x 1/4 screw with HXP head for securing dishwasher panels, brackets, and assemblies. Replaces stripped, missing, or damaged screws.

Secures the middle water feed tube to the upper rack in your dishwasher. Replace if cracked, broken, or missing to keep the conduit properly aligned.

Small clip that secures the tine row insert to your dishwasher rack. Replace if broken, cracked, or missing to keep dishes upright during wash cycles.

Secures the middle spray arm inside the dishwasher tub for proper alignment and rotation. Replace if cracked, broken, or missing to restore arm stability.

Dishwasher won't start, stops mid-cycle, or won't dry? The control module manages timing and powers all cycles. Moderate DIY repair restores function.

Cap assembly for dishwasher door. Installs on the interior door panel to seal openings. Replace if cap is missing, cracked, or broken during shipping.

Upper dishrack stop for dishwashers. Prevents the upper rack from sliding too far forward during loading and unloading. Replace if cracked or missing.

Covers the electrical junction box where the power cord enters your dishwasher. Replace if cracked, broken, or missing to protect wiring connections.

If your dishwasher door won't stay closed or pops open during cycles, the door strike may be broken. This latch component secures the door shut.

Secures dishwasher cabinet to chassis for improved stability. Replace if original brackets are broken, missing, or causing movement and panel gaps.

Replace your dishwasher's worn, broken, or missing timer knob. Attaches to the timer shaft on the control panel to select and advance wash cycles.

NOTE: The clamps no longer come with the connector hose. The part number for the clamp is WD01X10322.

A replacement clamp that secures hoses or wiring to keep lines routed and stable, helping prevent rubbing, leaks and noise. Restores a reliable hold for tubing and harnesses so the appliance runs quietly and safely. What it does:

• Holds hoses, tubing or wire harnesses in place to reduce movement and chafing.
• Helps prevent leaks and water line abrasion caused by loose fittings.
• Reduces rattling or vibration from unsecured lines or cables.
• Keeps routing organized so adjacent components aren't stressed or worn.

• Disconnect power before servicing the appliance; shut off water supply when working on water or drain lines.
• Remove the old clamp and position the replacement so it fully engages the hose or harness, avoiding twists.
• Use appropriate hand tools (pliers or screwdriver) and secure the clamp evenly; avoid overtightening.
• Inspect surrounding hoses and wiring for damage while installing; replace any components that show wear.

Replacement touch pad that restores your dishwasher's control interface. Needed when buttons are unresponsive, worn, hard to read, or the overlay is cracked.

Secures water tubing or wiring to your refrigerator cabinet. Replace if missing or damaged to prevent vibration, rubbing, or leaks. Confirm fit.

Door won't close or latch properly? This latch keeper secures the door strike so your dishwasher stays closed during cycles. Quick DIY repair.