General Electric Dishwasher Parts

Replaced the ring nut. Read more

Ordered a new detergent dispenser. Worked like a charm. Read more

Easily swapped it out myself. Read more

After reading all the systems on this site. It made it pretty easy to diagnose the problem. The part came in and slapped it in within a few minutes. Ran it and made my wife happy. She was under undue stress without her dishwasher and now I am her superman! Will order again from you. Part arrived quickly and the info you provided really saved me a ton of money! Seriously thank you. Read more

• Leaking

The video was very helpful. the hardest part is getting off old rusted parts. I had to use a hacksaw to remove one of the old clamps. I had to open the bottom of the washing machine to remove of the other clamp. Putting the new parts on was easy. Getting everything apart was a challenge. Putting the new parts on was an easy 5 minute job. Read more

I ordered new parts through your website and it solved my problem works like new Read more

The replacement drain pump was a little labor intensive, but worth it due to the cost of the part. Read more

It went very well and want to thank you for your prompt and professional response. Read more

1. Replaced the Dishwasher motor and pump assembly. 2. Replaced the lower arm sprayer. 3. Replaced the Sump and filter. Replaced both the inlet and outlet hoses. 4. Replaced the Airgap. 5. Replaced Float Dome. 6. Replaced Water Inlet Valve. Parts $220 for Dishwasher Estimated Labor $400.00 Labor $0.00 Parts $100.00 for Pullout Faucet Estimated Labor $175.00 Labor $0.00 Read more

• Won't start

Literally took no more than 15 minutes. I unscrewed the back panel of the door, unplugged the old keypad and pealed off the old keypad. I used rubbing alcohol to thoroughly clean the surface where the new keypad would go. Then I slid the new keypad into place and plugged it in. Peal off the adhesive backing and stick the new keypad down, reattach the door panel and you are good to go. Read more

I pulled the dishwasher out by removing screws that go into countertop. I then turned the adjustable screws on the front legs of the dishwasher enough to make sure I can slide the unit out. Slid the unit out a litte more than a foot. Moved the insulation off the sides saw the screws to put on the new guides removed the screws removed old guides put on new guides tighten screws and put the dishwasher back in place. Read more

I ordered a control tactile asm kit which gave me the new board for the controls. All I had to do was use a screwdriver to take out the old board and connect in the new board. I'd never done anything much like this before but it truly only took me a few minutes! Read more

I was told by the person who took my order that I could find an instruction video on you tube . So I went there and follow those instructions. The repair went well although I did have a slight problem with the door latch and the soap dispenser lever. They both fell out as I was trying to install the timer, but I went back to the video and although it didn't show how to replace these two parts I was able to see how they were placed and was able to figure it out from there. The job was a complete... Read more

I ordered both the front long panel and the lower access panel in the new color. I watched the instructional videos which were very helpful. I was very careful to remember where all the screws belonged as I took it apart. The panel required an extra small attachment to fit due to a change in design. These were included in the box along with clear instructions. It took about an hour to put back together, but I encountered no problems. The dishwasher now looks great. If I had not found this... Read more