General Electric Dryer Wire, Harness, Power Cord

This gas valve wiring harness connects the oven/range gas valve and temperature control circuit to restore reliable ignition and temperature sensing. It replaces a worn or damaged harness to help appliances light consistently and respond to controls. What it does

• Carries low-voltage signals between the control/thermostat and the gas valve for normal ignition
• Replaces frayed, burned, or broken wires that can cause intermittent ignition or no-heat conditions
• Helps resolve symptoms such as the burner failing to light, oven not maintaining set temperature, or control/ignitor not responding
• Provides factory-style connectors for a direct replacement and correct fit

• Turn off electrical power and shut off the gas supply before starting work
• Verify correct connector orientation and routing to avoid pinching or heat exposure
• Make secure connector connections and use proper strain relief or clips where applicable
• After installation, restore power/gas and test for correct operation and gas leaks

This main wiring harness connects the control and ignition components on a gas range so the cooktop and oven receive power and signals. Replacing a damaged harness restores reliable electrical connections and safe operation. What it does:

• Routes power and signal wiring between the console, igniters, valves, sensors, and other range components
• Enables spark ignition and control communication for burners and oven functions
• Protects circuits from misrouting or chafing that can cause shorts or failure

• Disconnect electrical power and shut off the gas supply before starting work
• Inspect connectors and terminals for damage; replace if corroded or brittle