General Electric Range / Cooktop / Oven Clip Or Clamp

This conduit clamp secures 1/2" electrical conduit or flexible armored cable to the appliance chassis, keeping wiring routed and strain-relieved for safe operation. It's a small replacement part used where the conduit passes into the control box. What it does

• Holds 1/2" conduit or flexible armored cable firmly at the entry point to the appliance cabinet.
• Provides strain relief to reduce stress on internal wiring and connections.
• Helps maintain proper wiring routing to prevent chafing or interference with components.
• Commonly used on ranges, ovens and other appliances that require a conduit connection to the control area.

• One conduit clamp (1/2") as shown.

• Always disconnect power to the appliance before servicing electrical components.
• Remove access panel to reach the mounting location; position clamp around the conduit and secure against the chassis.
• May require a small screw or nut to fasten.
• If wiring appears damaged or loose, inspect and repair wiring before reapplying power.

Secures wire connections to the terminal block in your range. Replace if cracked, loose, or causing poor electrical contact. Verify fit with your model.

This lower trim clip secures the appliance's lower trim or kickplate, keeping panels aligned and preventing rattles or gaps. It's a small but essential fastener for a finished, stable exterior. What it does:

• Holds the lower trim or kickplate in place to keep the front panel aligned
• Prevents trim from sagging, rattling, or separating from the cabinet
• Restores a secure fit after a broken or worn clip
• Works behind the trim to keep visible edges flush for a clean appearance

• The lower trim clip shown

• Disconnect power to the appliance before starting work to avoid electrical hazards
• Access the clip by removing the lower trim or kickplate per your model's service instructions
• Use appropriate hand tools and gentle pressure to avoid cracking trim pieces
• Replace any damaged clips with matching parts; inspect surrounding fasteners for wear

This panel clip secures a trim or control panel to the appliance cabinet, keeping the panel aligned and preventing movement or rattling. It's a small replacement clip used when the original clip is cracked, broken or missing. What it does:

• Fastens a trim or control panel to the appliance cabinet to maintain a flush fit
• Helps prevent panel vibration, noise and gaps that can expose internal components
• Replaces worn, cracked or broken clips that no longer hold the panel securely
• Restores proper panel alignment after panel removal or repair

• Disconnect power to the appliance before attempting any repair to avoid shock
• Remove trim or panel per service instructions to access the clip location
• Clip installs by snapping into the panel or cabinet slot; avoid forcing to prevent damage
• Replace any additional damaged clips for even alignment and secure fit

Oven mounting clip secures internal components in place. Replace if broken, loose, or missing to restore proper part alignment and prevent rattling.