General Electric Range / Cooktop / Oven Control Board

Fix an oven that won't heat, shows error codes, or has a non-responsive display with this electronic control board. Restores all oven functions.

This relay board assembly controls and routes power to key appliance components, restoring reliable switching for motors, compressors, or heating elements. Replacing a failed relay board can resolve intermittent operation and restore normal function. What it does:

• Switches power to major loads so motors, compressors, or heaters run when commanded
• Replaces worn or failed relays that cause intermittent starts or clicking noises
• Helps stop erratic operation or loss of function in affected circuits
• Prevents overloads from passing through a damaged relay assembly (when replaced)

• One relay board assembly

• Disconnect power to the appliance before starting any repair to avoid shock or damage
• Handle the board carefully; avoid touching contacts and use ESD precautions if available
• Verify connector orientation and seat all wiring harnesses fully during reassembly

Fix a range clock that won't display time or control oven functions with this timer control board. Complex repair—professional installation recommended.

Oven won't reach temperature or displays error codes? This electronic control board manages oven timing, temperature control, and self-clean functions.

Fix an oven that won't maintain temperature or stops mid-cycle. This relay control board regulates oven elements. DIY-friendly, typically 20-30 minutes.

Fix an oven that locks up or won't respond to controls with this control board. Monitors and regulates temperature settings for reliable operation.

The Encoder Assembly is an OEM part for GE gas ranges. It digitally converts analog knob movements into signals to control the gas valve, igniter, and temperature settings. 

Causes of a bad encoder assembly include degradation of internal sensors and switches over time, loose wiring connections, or impacts that cause misalignment.

Symptoms of a bad encoder assembly are:

• Delays or errors when trying to light burners
• Inaccurate flame height and temperature level responses 
• Knobs feel sticky, sluggish or jump between settings
• Error codes indicating control module communication issues

This GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore gas range models.

Fix error codes, blank displays, or unresponsive controls with this oven electronic control board. Restores timed cooking and temperature management.

Range not heating or igniting? This control relay board routes power to igniters and burners. Fixes intermittent operation and failed starts on gas ranges.

This is an electronic oven control board that manages oven temperature, cooking modes, and clock functions. It receives input from the keypad and controls the bake and broil circuits to maintain the set temperature. Replace this board if the oven does not heat, displays error codes, has an unresponsive control panel, or if the clock and timer functions are malfunctioning.

Fix unresponsive controls or blank displays on your range with this control display module. Direct-fit replacement for precise temperature control.

Fix an oven that won't start, beeps constantly, or has unresponsive buttons. This control board regulates bake, broil, and timer functions. DIY repair.

Fix burners that won't ignite or turn off when your gas range control knobs aren't responding. This reed switch board detects knob positions.

Fix unresponsive buttons, blank displays, or erratic oven temperature with this electronic control board. Requires moderate skill to replace safely.

Fix an oven that won't heat, has a blank display, or shows error codes with this control board clock. Restores timer and temperature functions.

This display board controls the time and temperature readout on the front of the range, typically using a VFD (vacuum fluorescent display) screen. It communicates with the main control board to show oven temperature, cook time, and clock functions. Replace this board if the display is dim, flickering, showing incorrect readings, or completely blank while the range otherwise powers on.