General Electric Range / Cooktop / Oven Motor

This control cooling fan assembly circulates air through the oven's control compartment to remove heat. By keeping the console and electronics cool during and after cooking, it helps prevent overheating and protects sensitive components.

• Moves air across the control area to dissipate heat from the board, wiring, and trim
• Runs during/after bake or broil to maintain safe cabinet temperatures
• Typical failure signs: fan doesn't run, loud vibration/squeal, control area feels very hot, or heat-related shutdowns
• Purpose-built for the control compartment; distinct from the convection fan inside the oven cavity

• Disconnect power at the breaker and allow the appliance to cool; wear cut-resistant gloves
• Access is typically from the rear or top; remove panels/guards per your model's service information
• Transfer any required brackets or ducts; secure so the wheel spins freely with no rubbing
• Reconnect wiring as originally routed, keeping harnesses clear of the blade; test operation before reassembly

Fix squealing noises or convection that shuts down after preheating. This oven fan motor circulates air for even baking and roasting. Common DIY repair.

This is a cooling fan assembly that mounts inside the oven and circulates air to prevent the control panel, electronics, and surrounding cabinetry from overheating during use. It is not the convection fan used for cooking - it is specifically designed to cool the oven's external components. Replace this assembly if the oven shuts off unexpectedly due to overheating, the fan is noisy or not spinning, or you notice excessive heat around the oven controls.

This fan assy transformer converts and routes power for the appliance fan motor so the cooling/blower fan operates reliably. Replacing a failed transformer restores proper fan function and helps maintain correct internal temperatures. What it does:

• Supplies the correct voltage/current to the fan motor so the blower/cooling fan runs as designed
• Helps prevent fan stalling or intermittent operation caused by a failing transformer
• Can resolve overheating symptoms or poor cooling tied to a non-functional fan circuit
• Works as the electrical interface between the appliance control system and the fan motor

• Always disconnect power to the appliance before inspecting or replacing electrical components
• Handle wiring and connectors carefully; match terminal positions and wire colors during reinstall
• Inspect mounting hardware and grommets; replace any damaged clips or insulation to prevent vibration noise

Fix uneven baking or a non-working convection mode with a new range convection fan motor. Restores proper air circulation for consistent cooking results.