General Electric Range / Cooktop / Oven Wire, Harness, Power Cord

A ribbon connector assembly that links control boards and user interface components with a flexible flat cable, restoring signal connections for responsive controls. Use this exact replacement when the existing ribbon is damaged, torn, or intermittently failing. What it does:

• Provides a flexible flat cable connection between electronic control and display/keypad assemblies.
• Restores reliable signal transmission when the original ribbon is cracked, delaminated, or has broken conductors.
• Helps resolve intermittent controls, unresponsive buttons, or display communication faults caused by a damaged ribbon.
• Maintains factory routing and pin alignment for proper board-to-board connection.

• One ribbon connector assembly (flat flex cable)

• Disconnect power to the appliance before inspecting or replacing electronic components to avoid shock or damage.
• Handle the ribbon cable by its reinforced ends and avoid bending near the termination points to prevent conductor breakage.
• Verify connector orientation and seating; ensure locking tabs are fully engaged for a secure connection.

Size: 14 inches. GY

Size: 24 inches

Size: 6 inch

Size: 14 inch

Size: 26 inch

This 14 AWG green lead wire provides a replacement grounding/conductor wire for compatible appliances, restoring secure electrical connections and reducing risk of poor contact or intermittent power. Designed to match OEM wiring size and color. What it does:

• Carries ground/ circuit connection for electrical components where a 14 AWG green conductor is required
• Restores a broken, burnt, or corroded wire that can cause intermittent operation or arcing
• Provides correct wire gauge and color coding for safe, code-consistent repairs
• Helps re-establish a firm terminal connection when original insulation or conductor is damaged

• One 14 AWG green lead wire (single wire as shown)

• Always disconnect power at the breaker or unplug the appliance before beginning work
• Route and secure the wire away from heat and moving parts; tighten terminals to manufacturer torque specs if provided