General Electric Range / Cooktop / Oven Wire, Harness, Power Cord

This wiring harness connects the appliance control keypad to the main control assembly, restoring reliable keypad signaling and touch response. Designed to replace a damaged or faulty keyboard harness for proper console operation. What it does:

• Transfers keypad/button signals to the control board so commands are registered.
• Replaces frayed, broken, or corroded wiring that can cause intermittent or no response from the keypad.
• Helps resolve symptoms such as unresponsive buttons, erratic console behavior, or control errors related to the keypad connection.
• Maintains correct connector fit and wire routing to preserve factory electrical paths.

• One keyboard wiring harness as shown.

• Disconnect power to the appliance before starting any repair to avoid shock or component damage.
• Handle connectors gently; align and seat each plug fully to ensure secure electrical contact.
• Route the harness following factory clips and channels to prevent pinching or heat exposure.

This wiring harness connects serial/dual circuit signals between controls and oven components, restoring reliable electrical communication. It replaces a damaged or worn harness to help components respond correctly. What it does

• Routes serial/dual signal and power between the control board and oven components
• Restores electrical connections that can cause intermittent or no component response
• Helps resolve failures caused by frayed wires, broken connector pins, or heat-damaged insulation
• Matches OEM connector types and wire groups for a direct replacement

• One wiring harness

• Disconnect power to the appliance before beginning any work to avoid shock or injury
• Verify connector orientation and pin count match the original before installation
• Handle connectors gently and secure wiring away from sharp edges and high-heat areas

This harness module connects and routes electrical signals between components to restore reliable circuit connections and control communication. It replaces a damaged or worn module to help appliances power and operate correctly. What it does:

• Routes power and signal connections between internal components to ensure consistent electrical continuity
• Replaces broken, frayed, or corroded wiring that can cause intermittent operation or loss of function
• Helps resolve symptoms such as lights or controls not responding, intermittent cycles, or non-start conditions when traced to the harness
• Maintains correct connector fit and pin alignment for secure component mating

• One harness module as shown

• Disconnect power before servicing to avoid shock or damage
• Inspect connectors and mating components for damage or corrosion before installation
• Secure harness away from sharp edges and moving parts; follow OEM routing and fastening points

This high-voltage harness routes power to the microwave's high-voltage components, restoring reliable high-voltage connectivity for heating. Use this harness to replace a damaged or burned HV lead to help the microwave heat consistently. What it does:

• Transfers high-voltage power from the transformer to the magnetron and other HV components
• Replaces cracked, burnt, melted, or corroded wiring that can cause intermittent heating or arcing
• Helps stop visible arcing, burning smells, or sparking inside the microwave cavity when HV wiring is compromised
• Restores secure, insulated connections for safe high-voltage operation

• One high-voltage harness/lead as pictured

• High-voltage components retain lethal charge; unplug appliance and discharge the capacitor before servicing
• Match all connectors and routing to the original harness to maintain insulation clearance and component spacing
• Inspect adjacent components (capacitor, diode, magnetron) for damage; replace any visibly damaged parts