Hotpoint Range / Cooktop / Oven Parts

I changed the motherboard - computer and also changed the motor in the freezer, because it was doing a howling sound every time it turned on. The repair technician asked for $500 for a repair and that is on top of the $230 I paid him two days before. I looked up the parts and decided to try myself and it paid off. Great instructional videos. Thanks Read more

• Oven is too hot
• Little to no heat when baking
• Won't start

The repair was relatively simple and quick. The only part required was a new oven thermostat assembly and the tools I used for my model was a flathead screwdriver, cross-point screwdriver, torque bit and 1/4 inch socket using a bit driver. To complete the repair, I did the following: 1. Remove all top stove burner pieces and place to the side. Remove the 3 three screws (torque bit) in each of the 4 burner locations. That will allow the top lid to separate from the main unit later. 2. Pull... Read more

Ordered parts ( very easy) and replaced old ones . Pop out, pop in. Simple but it made my stove and oven new again. Read more

• Touchpad does not respond
• Will not program

I found exploded parts view of oven and looked for oven sensor probe and control card parts. I also looked at great videos and read past repair stories. I decided the problem had to be one of the two parts (probe or card) and ordered both. I decided that the probe should be changed first rather than involve a circuit card. I changed the probe and tested the oven and it works again. Read more

Removed damage terminal block ordered new block on line. when I received new block installed it stove works fine easy to replace. If I had not been home at the time when this happen it may had cause a big house fire. Read more

Looked up the part number at Appliance Part Pros, ordered the window pack (received it the next day), and replaced the glass assembly. Was generally able to follow illustrated parts breakdown as a guide. Read more

• Little to no heat when broiling

I needed to replace the oven broil element on my 15 year old GE range/oven unit. The broil element was broken in half during an oven self-cleaning cycle. Due to the age of the oven, I decided to replace both the broil and bake elements. I ordered the elements from Appliance Parts Pro. Their web site made it very easy to identify and locate the correct replacement parts. The parts arrived in 2 days. I watched the repair demo videos available for each element. Although the oven used in the demo... Read more

The previous tenant in my daughter's new apartment apparently had a grease fire of sorts in the GE XL44 gas oven. This left the insulating double glass panes so fouled up that one could not see into the oven. I removed the oven door (just lifts off the hinges) and proceeded to disassemble the door so as to get to the glass panes. That's when the real problems arose: the window seal rope, which lays around the edge of the opening to the oven, was burnt to a crisp -- see photos. The oven... Read more

Ordered new parts and replaced all. Had to slightly modify the wire terminals all four surface elements so that they would fit the ceramic insulators that were shipped with each one. Read more

Removed 2 outer screws that held on handle and 4 inner screws which held on handle to outer panel. Installed new handle with 4 screws and installed outer 2 screws with spacers which were in door. Read more

Replaced the large burner control switches for the ones giving trouble. Since the other two switches had seen as much use as the faulty ones, replaced them too. After putting in new switches, found that one large burner had burned out so replaced it also. Range now cooks as good as new Read more

I ordered both hinges (if the nylon roller was bad on the left, it was probably going to go bad on the right side as well). The web site was easy to navigate, order process simple. Hinges arrived quickly. Slide the oven door up and off. unscrew the three screws for the hinge. You need to then pull up with some force (there is a big spring in there), and twist the hinge to get the last bit out. I used a hemostat to hold the spring and keep it from falling back into the hole. removed the... Read more

Initially, I took it off, sanded it and painted with appliance touch-up. Still didn't look good so I ordered a replacement part and installed. Read more

• Door won't close

I ordered both hinges (if the nylon roller was bad on the left, it was probably going to go bad on the right side as well). The web site was easy to navigate, order process simple. Hinges arrived quickly. Slide the oven door up and off. unscrew the three screws for the hinge. You need to then pull up with some force (there is a big spring in there), and twist the hinge to get the last bit out. I used a hemostat to hold the spring and keep it from falling back into the hole. removed the... Read more

Put in a new 6" surface burner. Read more

Fast delivery, great service Read more