Jenn-Air Axle, Roller, Pulley Parts

Bought new strip then found that both of the wheels had worn flats on them and had to purchase newwheels. Read more

Acualy sounded and looked major but with a littel help with you tube the job only took 30 minutes. 3 bolts for the water pump pulley broken pulley poped off new one klick into place simple belt install good to go. Parts saved me $40 and where here in only 2 days. I couldnt be happyer. Read more

Ordered new frame, wheels and SS slide for the bad side. Job was done in 10 minutes and the rack now works smoothly. Read more

Decided to order the kit with both rollers even thou the right one looked OK.Also ordered the pulley for the idler. Watched the video for the pulley installation,super helpful on a couple of the steps!! Everything went great. A 14 year old dryer still has life! Parts ordering and delivery was also great!!! Thank you. Read more

Un plugged dryer. It was an easy fix, popped the top up. Removed the two screw that held the front on and also unclipped the door switch. Released tension that was on belt and removed drum. Removed old front slides cleaned up area and replaced them. Popped the ring that held the rear drum wheels and placed the new ones with a dab of grease. Un hooked tension spring for idler and removed old one and put the new one in. Make sure you place it through the correct hole and it makes it firmly into... Read more

Replaced left hand rack adjuster. Read more

Had to unscrew the axel bolt & remove broken plastic wheel & replace it with the new plastic wheel. Easy fix. Then install newly repaired dish washer. Read more

Found the parts I needed on the Appliance Parts Pros website. Went to my local appliance store with the pictures from the website, and they did not agree that the replacement rack roller was what I needed. I was to return with a picture of my Dishwasher upper rack to show them. This was a 30 mile round trip, that I was going to have to do again before the parts I needed would even be ordered. Came home, went back to Appliance Parts Pros website and ordered the 2 items I needed. They... Read more

Replaced the roller and shaft. The roller had worn 1/4 of the way through the support shaft. Read more

• Will not agitate
• Burning smell

The washer was on, and I heard a faint humming sound in the laundry room. I went in and opened the washer and it was full of soapy water in the middle of its cycle and was not agitating. I also smelled a faint burning smell. At this point I figured the problem was a bad motor, as the washer is more than 20 years old. I have fixed it twice before, because the first time, the repairman said I should keep this washer going as long as possible. It was made to last with a metal drum, unlike newer... Read more

Replaced rollers which were easy except i had to pull the dishwasher about half way out of the cabinet Read more