Kenmore / Sears Cap Or Cover

Color: Apollo Gray

Replacement sensor cover cap for your refrigerator. Protects internal sensors from dust and damage. Order a new cover if yours is cracked or missing.

This rear cover replaces the damaged or missing cabinet back panel to protect internal components and restore a finished appearance. It helps keep wires and motors shielded and prevents debris from entering the appliance. What it does:

• Shields the appliance's rear components (motor, wiring, vents) from dust and physical damage
• Restores proper airflow routing and helps reduce rattling caused by loose or broken panels
• Prevents accidental contact with internal electrical components and moving parts
• Common symptom: cracked, warped, or missing rear panel; noticeable noise, drafts, or exposed wiring

• Disconnect power before starting any work
• Removal typically requires backing out screws and lifting the old panel away; keep fasteners for reuse if undamaged
• Handle edges carefully to avoid cuts; wear gloves and eye protection
• Verify panel aligns with existing screw bosses and clips; do not force into place—confirm fit before tightening

Almond-colored cover for the upper hinge assembly on your refrigerator. Replaces cracked, discolored, or missing hinge covers to restore a clean look.

Black plastic cover that conceals the upper door hinge on your refrigerator. Replace if cracked, broken, discolored, or missing for a clean finish.

Plastic hinge cover for refrigerator doors. Replaces cracked, broken, or missing covers that expose the hinge mechanism. Snaps into place over door hinge.

Protective cover for the high voltage control unit in your refrigerator. Replace if cracked, broken, or missing to protect electrical components.

Grey right-hand hinge cover cap for bottom-mount refrigerators. Replace your cracked, broken, or missing hinge cover to restore a clean appearance.

This plastic filter cover protects the dishwasher's filter and sump, helping keep food and debris out of the pump while directing wash water through the filter area for proper draining and cleaning performance. What it does:

• Covers and secures the filter/sump area so debris is trapped before reaching the pump
• Helps channel wash water through the filter for effective filtering and draining
• Reduces risk of pump clogs and noisy operation from loose debris
• Commonly replaced when cracked, warped, or not seating properly which can cause poor draining or food re-deposit

• Disconnect power to the appliance before performing any service
• Remove the lower rack and lift out the filter assembly to access the cover
• Inspect and clean the filter and sump area before installing the new cover
• Refer to the appliance's diagram for correct orientation and fastening

Access panel cover that protects internal components and provides a finished look. Replace if the original is cracked, broken, or missing from your appliance.

Covers and protects the upper door hinge on your refrigerator. Replace if cracked, broken, or missing to restore a finished look and shield the hinge.

Protective cover for water valves and inlet hoses. Replace if cracked, broken, or missing to shield components from debris and accidental contact.