Kenmore / Sears Dishwasher Dispenser Parts

I watched the video on your site and it showed step by step how to replace the spring. Excellent shipping time. Good customer service on chat forum. Read more

This was a pretty easy fix. Removed the screws around the perimeter of the inside cover of the door and pressed the outer door cover upward to release it from slots retaining it. There are four wires to remove (2 for the detergent door release and 2 for the rinse agent release). Removed the 6 screws retaining the dispenser assembly and inserted the new one. Reassembly is simply in reverse order. Problem solved for less than the cost of a service technician's call! Read more

Replaced dispenser Read more

Appeared to be two problems: the latch was worn and one of the pins that slid in a guide on the actuator located in the inner panel had broke off. Detergent lid spring and pin appeared to be OK but decided to replace since I was aready working on it. I ordered all the inner panel mechanism from the control arm to the latch actuator on the inner panel. The repair was successful as the detergent dispenser now opens during its cycle. Read more

• Will not dispense detergent

I ordered a new vario motor and a soap dispenser. I turned off the water and the breaker, disconnected the water line and the power at the front base of the unit, disconnected the drain hose from the garbage dispenser, and pulled out the dishwasher and laid it on a blanket on its face. I unscrewed and removed the plainly visible vario motor on the bottom of the machine and removed the cam from the shaft. I then used a needle nose plier to carefully turn the D-shaft on the new motor to exactly... Read more

The cover was easy to remove with 3 star head screws. I entered my model number on AppliancePartsPros.com dreading the cost I was about the encounter. However, the parts were very cheap, in stock, and shipped within an hour of my order. I had a question about the tracking number and received an email back in less than an hour. The cost for both parts and standard shipping was under $30. Once I received the parts, the new cover was installed, the rest of the assembly was put back back... Read more

Repair parts arrived super fast. Installed the new parts according to the supplied instructions. All went well. It took over 2 hours because the unit had to be removed after the water and power were disconnected and then the initial problem diagnosed (motor brushes worn beyond service limits). The removal of the spray bar tower assembly was a challenge until it was discovered that the tower unscrews in a CW direction from the bar that then allowed access to the attachment screw that holds that... Read more

My husband expected we needed a new dishwasher but I insisted on trying to fix it first. You need a Torx screwdriver so make sure you have a set. A little difficult to get cover back on and lined up by myself, but I managed and this was my first attempt at major appliance repair. I replaced the entire console and the dispenser. Still working after 3 loads so my husband may have to eventually admit that I fixed it. Read more

• Will not dispense detergent

My husband Ron diagnosed the problem, that a new Soap dispenser assembly was needed. We ordered the part, and it arrived in 48 hours. The front dishwasher door was rusty, but my husband managed to dis-assemble and replace the dispenser. Pleased with purchase process. Part fit fine. Janie Read more

Order part to repair. Read more

1. Replaced the Dishwasher motor and pump assembly. 2. Replaced the lower arm sprayer. 3. Replaced the Sump and filter. Replaced both the inlet and outlet hoses. 4. Replaced the Airgap. 5. Replaced Float Dome. 6. Replaced Water Inlet Valve. Parts $220 for Dishwasher Estimated Labor $400.00 Labor $0.00 Parts $100.00 for Pullout Faucet Estimated Labor $175.00 Labor $0.00 Read more

Took door off, saw that dispenser linkage was ok, I could open and close by hand, so figured the wax motor or the wiring to it were most likely the problem. I took off the wax motor ( actuator) and ran 120 volts to it via jumper wires, and it did not move at all, so figured good chance that was the problem. Found part # on your site, received new one quickly from you, put it in and works great. Thanks. Read more

Ordered a replacement control panel and installed it according to the AppliancePartsPros.com YouTube video. Read more

• Will not dispense detergent

This happened after a repair man came out and replaced the timer. Not my doing landlord had a service contract. Once inspected I found when the timer was swapped he did not swap the cam over. Ordered the correct parts and repaired myself. Hard to find good help anymore. Read more