Kenmore Elite Gasket & Seal

Removed existing gasket and replaced with new gasket in less than 5 minutes. Very Easy. Make sure to remove the lower burner cover (inside the oven) which allows you to pull the end gasket material through the two circular openings in the frame. Read more

Ordered the parts online and fixed it myself. Read more

Dishwasher washer would not drain after hearing glass-like particles during the drain cycle despite trying to clean the cylinder filter. Originally suspected the drain motor was damaged. After watching a video on how to replace the drain pump, I carefully energized the dishwasher (from water and electricity) then removed the dishwasher to take a look. After removal of drain hose from the pump, discovered that drain hose was connected to water inlet assembly which also needed removal to... Read more

Removing was easy. Pull out the ends of the seal, the ends aren't locked in. Then, pull up on each retaining clip. Each clip is held in with spring tension. Reinstallation was easy too. Start on one end, Twist frayed end into cone-like shape and insert into one of the holes for the seal. Push in with a skewer/screwdriver. Insert first clip into the first hole. Go around in a linear fashion, inserting each clip into each hole. After the last clip is pushed in, twist the end of the frayed end... Read more

Had a local company in to estimate repair of gas range oven door glass that had fallen out. At this time had him provide me with an estimate for replacing the freezer door gasket because on several occasions recently the freezer door has frozen closed.His estimate was $110.00 for the part and $140.00 for the labor. He would need to order the gasket and needed 3-4 days to get it. I watched your video ordered the part for under $50.00 total . I received it within 2 days and installed it in under... Read more

First I watched the very, very helpful video (twice), then I planned out the job in regards to tools, work area, and access. I have stacked units of washer/dryer due to space restrictions and had to ask my son-in-law to help me lift the dryer of the washer once I had prepared the process by fabricating 2 pieces of 3/4" plywood to turn the dryer and then slide it out far enough were 2 people can lift it and then set it on some cribbing for easy handling. Disconnected the power, turned off the... Read more

Easy just pull clip and put back Read more

With the basket out of the dishwasher, the plastic parts basically snap on and off... popped the broken parts off and the new parts on. The 2 wheel and mount assemblies were a little more complicated. The video on the website advises to disconnect the supply line and drain line... I didn't have to do this. I just pulled the dishwasher out of its cabinet a little over a foot and removed the 2 screws holding each assembly in place and removed them. The previous gaskets (2 PER ASSEMBLY)... Read more

I watched AppliancePartsPros.com videos and went for it. Made it easy. Read more

The right door seal and the freezer door seal are easily removed and replaced. They just pull out of the slot. These 2 new gaskets push in easily. The left door has the French Door Mullion, that blocks the removal of the door gasket. There are two screws in the middle that holds it on, and there is a spring at the bottom of the mullion that keeps the mullion in place. The spring can easily be removed, or left in place. There is an electrical connector in the middle of the mullion. As suggested... Read more

My Whirlpool dishwasher was leaking out the bottom of the door. I replaced the gasket and the lower door seal. When I ran a test wash, it was still leaking. After reading more online, I found that it could be a cracked washer arm. The initial inspection of the washer arm looked normal but when I used my faucet to slowly pour water into the inlet of the arm, I noted that water was leaking through a seam and not just the holes where it should come out. I then tried running a wash without the... Read more