Kenmore Elite Parts

Upper door hinge assembly for bottom-mount refrigerators. Mounts at the top of the cabinet to support the door. Replace if cracked, broken, or lost.

Oven light not turning on when door opens? This door-activated switch detects door position and controls interior lighting. Easy push-in installation.

Replacement power cord for ovens and ranges. Installs at the rear panel to restore electrical connection. Needed when original cord is frayed or damaged.

If your refrigerator isn't cooling evenly or the freezer is noisy, the evaporator fan motor may have failed. This motor circulates cold air throughout.

This is an adjustable leveling leg that threads into the base of the dishwasher to support the unit and allow height adjustment. Proper leveling ensures the door seals correctly and water drains efficiently. Replace this leg if it is broken, stripped, or missing, which can cause the dishwasher to rock, leak, or not close properly.

This is the start button assembly that initiates the dryer cycle when pressed. It connects to the control panel and engages the dryer's motor circuit. Replace this button if it is stuck, broken, feels loose when pressed, or the dryer does not start when you push it.

Mounts inside the washer drum to lift and tumble clothes during the wash cycle. Replace if cracked, broken, or missing to restore proper agitation.

Mounts to the washer's lower frame to secure components and maintain alignment. Replace if bracket is cracked, broken, rusted, or missing hardware.

Convection fan motor that circulates hot air inside the oven cavity for even cooking temperatures. Replace if fan stops spinning or makes excessive noise during convection baking.

This is a roller assembly that attaches to the lower dishrack of a dishwasher, allowing the rack to slide in and out smoothly. The roller includes the wheel and its mounting bracket. Replace this part if the lower rack is difficult to pull out or push in, rolls unevenly, or if the existing roller is cracked, worn, or missing.

This adjustable leveling leg threads into the appliance base to set height and stabilize the cabinet. Replacing a worn or missing leg helps stop rocking and vibration and helps maintain proper alignment for reliable operation.

• Provides adjustable support at one corner of the appliance
• Helps level the unit for correct alignment with floor or cabinetry
• Reduces rocking, vibration, and rattling noises
• Replaces stripped, bent, cracked, or missing leg

• Disconnect power and, if applicable, shut off water before servicing
• Carefully support or brace the appliance to access the base safely
• Start the new leg by hand to avoid cross-threading; adjust height gradually
• Use a level to check side-to-side and front-to-back, then recheck after positioning

Washer won't start or runs intermittently? A faulty wiring harness disrupts power flow between components. This repair restores connections in 20-30 minutes.

Supports and centers the inner tub in front-load washers. Replace if cracked, corroded, or broken to restore proper drum alignment and balance.

Replace a cracked, warped, or missing grill grate on your range cooktop. Restores a sturdy, level grilling surface for safe support and even cooking.

Spider arm connects the wash basket to the drive shaft in front-load washers. Replace if cracked, corroded, or broken to restore proper basket support.

Replaces cracked or broken tube connector in your refrigerator. Secures and routes tubing to prevent leaks from loose connections. Easy install.