Kenmore / Sears Heating Element

This is the electric heating element located inside the warming drawer of a range. It provides low, steady heat to keep cooked food warm until serving. Replace this element if the warming drawer no longer heats, heats unevenly, or if the element is visibly damaged or burned out.

Fix a burner that won't heat with this range surface element. This electromagnetic coil transfers energy to heat cookware. Direct replacement part.

Burner not heating? This cooktop heating element restores consistent heat output. Common fix for cold or weak burners. Moderate DIY repair in 30-45 minutes.

Fix a burner that won't heat with this cooktop top heating element. Direct replacement for electric range surface coils. DIY-friendly repair.

Replace a weak or non-heating cooktop element. This heating element restores proper cooking temperature. Moderate DIY repair with basic tools required.

This is a radiant heating element that sits beneath the glass surface of an electric cooktop or range. It generates heat for cooking when a burner is turned on. Replace this element if a burner no longer heats, heats unevenly, or fails to reach the correct temperature despite the control functioning properly.

This heater sheath is the metal housing that surrounds and protects the dryer's electric heating element, helping direct heated air into the drum for normal drying. Replaces a damaged or corroded sheath to restore safe, efficient heating. What it does

• Holds and shields the heating element assembly to prevent contact with other components
• Directs airflow around the heating element so the dryer can produce warm air
• Helps maintain proper element alignment and electrical insulation
• Common symptom: dryer runs but produces little or no heat
• Common symptom: visible damage, rust, or burn marks on the element housing

• One heater sheath (heating element housing) as shown

• Disconnect power (unplug or switch off breaker) before servicing to avoid electric shock
• Handle the heating element and terminals carefully; sharp edges may be present
• Inspect element, thermal fuse, and wiring while the cabinet is open; replace only confirmed faulty parts

This is the bake heating element located at the bottom of the oven cavity. It provides the primary radiant heat used for baking and roasting. Replace this element if the oven is not heating, heats unevenly, or if the element has visible damage such as cracks, blistering, or burn-through spots.

Dryer not heating or taking too long to dry clothes? This laundry center heating element restores proper drying performance. Moderate DIY repair.

This bake element is the oven's main heating element that provides consistent heat for baking and roasting. Replacing a failed element restores proper oven temperature and cooking performance. What it does:

• Heats the lower oven cavity for baking and roasting cycles.
• Common symptom: oven does not heat or reaches lower-than-set temperatures.
• Common symptom: uneven baking or food undercooks on all racks.
• Also check for visible damage, burn marks, or broken connectors.

• Disconnect power at the breaker or unplug the appliance before starting any repair.
• Allow the oven to cool fully before accessing the interior; wear gloves to protect against sharp edges.
• Remove the oven cavity access panel or back panel as required to access element mounting screws and wiring.
• Verify wiring connections are secure and test the element for continuity with a multimeter before final reassembly.

Range not keeping food warm? This top warming element restores consistent low-heat warming. Common fix for cooktops with non-heating warming zones.