Kenmore / Sears Refrigerator Door Stop Or Cam Riser

Your "How to" video made it look simple and it was. I ordered the small part - it arrived the next day and I replaced the part in less than 15 minutes! I had a similar experience with my close dryer. You guys are great! Read more

Replaced both sets of door cams on my Kenmore Elite Refrigerator. The most important thing to know is that you DO NOT have to remove the doors from the refrigerator to replace BOTH sets of cams. You just have to remove the lower grill which is a snap fit (I also turned off the water and unplugged the unit). My fridge has an ice and water dispenser where the water and electrical lines go through the cams on the left side. Be sure to order the correct parts as the cam holes on the freezer side... Read more

The plastic bearing broke after 7 years of too much opening and closing. Removing original bears were not real easy, however installing new ones were quick. It works well. The parts arrived really quickly. Read more

Replaced the hinge cam riser. As suggested I replaced hinge cam risers for both doors. Read more

First part ordered using chat assistant did not fix problem, spoke to technician who refunded first part and ordered another part. second part fixed problem. Read more

I ordered the door hinge cam kit, both the hinge, lower and upper cam. I followed videos found on the web. I would recommend taking the refrigerator door off by removing the upper hinge bracket and lifting the door off the lower hinge. It was much easier to replace the hinge and cam with the door off. One video suggested using Di-electric grease to lubricate the cam surfaces. Read more

Removed the lower hinge and repaired it, It was bent, allowing the bottom of door to rub on the inside of refrigerator. With the parts purchased along with the repair made to the hinge. The door now works as it should. Read more

Emptied the door, removed the top door hinge plate, removed the door, then removed the damaged lower hinge plate and bushing, and then replaced them with the new parts. Everything went back together just fine, and now the door closes properly, and stays closed! Thanks!! Read more

Replaced the upper and lower cam riser (plastic parts) on the lower hinge. APP's YouTube video was the reason I decided I could do this myself. My daughter helped. :) Tip: replace both the upper and lower even though the lower usually breaks first. The upper will sustain damage from the jagged edges of the broken lower one. I also bought the replacements for the refrigerator side. They cost less than the freight charge and seems like they will fail eventually since they're the same... Read more

Replaced all the parts ordered and adjusted door. Took about one hour to complete. Read more

Replaced stopper. Read more

Takes two people. Place a blanket down on the floor or table so you have something soft to set the doors on. Turn off the unit. Lifted unit up slightly in front to retract leveling feet. Lowered onto its wheel(s). Rolled unit away from wall. Turned off ice-maker water. Opened doors and removed plastic cover below the fridge and freezer by removing two screws and holding doors at 90 degree open position. Placed rags under freezer and disconnected three wire connectors and two water tubes... Read more