Kenmore / Sears Shaft Or Pin

This replacement agitator shaft restores the connection between the washer transmission and agitator so laundry moves properly during the cycle. Replaces a worn or damaged shaft to help eliminate agitation failure and restore normal washing action. What it does:

• Transfers rotational force from the transmission to the agitator so clothes are moved and cleaned
• Commonly replaced when the agitator refuses to move, spins freely, or washing action is inconsistent
• Can address grinding or knocking noises coming from the transmission/agitator area
• Works as a direct-fit service part when matched to the correct washer model

• Disconnect power and water before beginning any repair
• Follow the washer's service manual or OEM exploded diagram for removal and installation steps
• Inspect surrounding components (agitator, transmission seals, fasteners) and replace if worn

Drive rod that connects the agitator to the transmission system in top-load washers. Replace if bent, broken, or worn to restore proper agitator movement.

Support rod that holds the cooktop top in place. Replace this structural pin if the original is broken, bent, or missing to properly secure the top.

Light switch rod for ranges. Connects the exterior light switch button to the interior switch mechanism. Replace if broken, worn, or missing.

Locator pin for washer assembly. Secures and aligns components during installation. Replace if broken, missing, or worn to ensure proper part positioning.

Drawer slide rod for bottom-mount refrigerators. Replaces bent, broken, or worn rods that cause drawer alignment issues or difficulty sliding.

Replacement broiler pin for gas ranges. This metal pin secures the broiler drawer in place. Order a new pin if your original is bent, broken, or missing.

Replacement retaining pin that secures the lint blade inside your dryer's lint filter housing. Needed when the original pin is broken, missing, or worn.

This compressor mounting pin secures the refrigerator compressor to its mounting bracket, helping reduce vibration and noise for reliable operation. It's a simple, rugged fastener used where the compressor meets the cabinet base. What it does:

• Anchors the compressor to the mounting bracket to limit movement and vibration
• Helps reduce compressor-related rattling or banging noises during operation
• Maintains proper compressor alignment to protect refrigerant lines and electrical connections
• Works with existing mounts and brackets as shown in OEM diagrams

• One compressor mounting pin

• Disconnect power and unplug the appliance before accessing the compressor area
• Support the compressor and attached lines before removing or installing mounting hardware
• Use appropriate hand tools and follow OEM diagram locations for correct placement

Replacement mounting stud for refrigerators. Secures components and panels in place. Order a new stud if yours is stripped, broken, or missing.